[PATCH] firmware: arm_scmi: bus: bypass set fwnode for scmi cpufreq

[Peng Fan (OSS)]

From: Peng Fan <peng.fan at nxp.com>

Two drivers scmi_cpufreq.c and scmi_perf_domain.c both use
SCMI_PROTCOL_PERF protocol, but with different name, so two scmi devices
will be created. But the fwnode->dev could only point to one device.

If scmi cpufreq device created earlier, the fwnode->dev will point to
the scmi cpufreq device. Then the fw_devlink will link performance
domain user device(consumer) to the scmi cpufreq device(supplier).
But actually the performance domain user device, such as GPU, should use
the scmi perf device as supplier. Also if 'cpufreq.off=1' in bootargs,
the GPU driver will defer probe always, because of the scmi cpufreq
device not ready.

Because for cpufreq, no need use fw_devlink. So bypass setting fwnode
for scmi cpufreq device.

Signed-off-by: Peng Fan <peng.fan at nxp.com>
---
 drivers/firmware/arm_scmi/bus.c | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/drivers/firmware/arm_scmi/bus.c b/drivers/firmware/arm_scmi/bus.c
index 96b2e5f9a8ef..84c8e2714cfa 100644
--- a/drivers/firmware/arm_scmi/bus.c
+++ b/drivers/firmware/arm_scmi/bus.c
@@ -395,7 +395,8 @@ __scmi_device_create(struct device_node *np, struct device *parent,
 	scmi_dev->id = id;
 	scmi_dev->protocol_id = protocol;
 	scmi_dev->dev.parent = parent;
-	device_set_node(&scmi_dev->dev, of_fwnode_handle(np));
+	if (!(protocol == SCMI_PROTOCOL_PERF) || strcmp(name, "cpufreq"))
+		device_set_node(&scmi_dev->dev, of_fwnode_handle(np));
 	scmi_dev->dev.bus = &scmi_bus_type;
 	scmi_dev->dev.release = scmi_device_release;
 	dev_set_name(&scmi_dev->dev, "scmi_dev.%d", id);
-- 
2.37.1