Hardkernel Odroid-M1S no USB 2.0 & Ethernet

[Daniel Martin]

Hi,

Currently the Odroid M1S based on the RK3568 processor is not enabling
Ethernet or the USB-A 2.0 port on the device.

Here is the output of ethernet failing.

[    0.351616] rk_gmac-dwmac fe2a0000.ethernet: IRQ eth_lpi not found
[    0.351640] rk_gmac-dwmac fe2a0000.ethernet: IRQ sfty not found
[    0.352311] rk_gmac-dwmac fe2a0000.ethernet: supply phy not found,
using dummy regulator
[    0.352467] rk_gmac-dwmac fe2a0000.ethernet: clock input or output? (output).
[    0.352484] rk_gmac-dwmac fe2a0000.ethernet: TX delay(0x4f).
[    0.352499] rk_gmac-dwmac fe2a0000.ethernet: RX delay(0x2d).
[    0.352520] rk_gmac-dwmac fe2a0000.ethernet: integrated PHY? (no).
[    0.357610] rk_gmac-dwmac fe2a0000.ethernet: init for RGMII
[    0.358099] rk_gmac-dwmac fe2a0000.ethernet: Version ID not available
[    0.358120] rk_gmac-dwmac fe2a0000.ethernet: DWMAC4/5
[    0.358135] rk_gmac-dwmac fe2a0000.ethernet: DMA HW capability
register supported
[    0.358146] rk_gmac-dwmac fe2a0000.ethernet: Ring mode enabled
[    0.358174] rk_gmac-dwmac fe2a0000.ethernet: device MAC address
b6:bf:27:ec:65:d4
[    0.358191] rk_gmac-dwmac fe2a0000.ethernet: Enabled RFS Flow TC (entries=10)
[    0.358210] rk_gmac-dwmac fe2a0000.ethernet: Using 32/32 bits DMA
host/device width
[   16.932085] rk_gmac-dwmac fe2a0000.ethernet eth0: Register
MEM_TYPE_PAGE_POOL RxQ-0
[   16.932837] rk_gmac-dwmac fe2a0000.ethernet eth0: validation of
with support 00,00000000,00000000,00006000 and advertisement
00,00000000,00000000,00000000 failed: -EINVAL
[   16.932924] rk_gmac-dwmac fe2a0000.ethernet eth0: __stmmac_open:
Cannot attach to PHY (error: -22)

The Odroid M1S uses the RTL8211F Gigabit Ethernet chipset. The phy
kernel driver is enabled - `CONFIG_REALTEK_PHY=y`.

Obviously this works with the Hardkernel 5.10 linux kernel & supporting DTS.
Let me know what further information you may need.

Kind Regards,

Daniel