[PATCH v5 2/3] arm64: dts: ti: k3-am642-evm: add ICSSG1 Ethernet support

[Wadim Egorov]

Hi,

Am 15.02.24 um 11:30 schrieb MD Danish Anwar:
> ICSSG1 provides dual Gigabit Ethernet support with proper FW loaded.
> 
> The ICSSG1 MII0 (RGMII1) has DP83869 PHY attached to it. The ICSSG1 shares
> MII1 (RGMII2) PHY DP83869 with CPSW3g and it's assigned by default to
> CPSW3g. The MDIO access to MII1 (RGMII2) PHY DP83869 is controlled by MDIO
> bus switch and also assigned to CPSW3g. Therefore the ICSSG1 MII1 (RGMII2)
> port is kept disable and ICSSG1 is enabled in single MAC mode by
> default.

sorry for bumping this old thread, but I was about to add PRU-ICSSG 
nodes for the phyBOARD-Electra and noticed a difference in the firmware 
names.

[snip]
> +	icssg1_eth: icssg1-eth {
> +		compatible = "ti,am642-icssg-prueth";
> +		pinctrl-names = "default";
> +		pinctrl-0 = <&icssg1_rgmii1_pins_default>;
> +		sram = <&oc_sram>;
> +		ti,prus = <&pru1_0>, <&rtu1_0>, <&tx_pru1_0>, <&pru1_1>, <&rtu1_1>, <&tx_pru1_1>;
> +		firmware-name = "ti-pruss/am64x-sr2-pru0-prueth-fw.elf",
> +				"ti-pruss/am64x-sr2-rtu0-prueth-fw.elf",
> +				"ti-pruss/am64x-sr2-txpru0-prueth-fw.elf",
> +				"ti-pruss/am64x-sr2-pru1-prueth-fw.elf",
> +				"ti-pruss/am64x-sr2-rtu1-prueth-fw.elf",
> +				"ti-pruss/am64x-sr2-txpru1-prueth-fw.elf";

Where do these firmware names come from? All references I can find use 
am65x-sr2*: ti-linux-firmware, meta-ti and so on.
Are we expecting the the names to be renamed for linux-firmware?

Regards,
Wadim