[PATCH v5 3/6] dt-bindings: serial: add binding for rs485 rx-enable state when rs485 is disabled

Farouk Bouabid farouk.bouabid at theobroma-systems.com
Fri Jan 26 09:27:44 PST 2024


RS485 can have a receiver-enable gpio (rx-enable-gpios). When rs485 is
enabled, this gpio, if provided, must be driven active while receiving.
However when RS485 is disabled this gpio should not have an undefined
state. In that case, as DE and RE pins can be connected both to this gpio,
if its state is not properly defined, can cause unexpected transceiver
behavior.
This binding depend on rx-enable-gpios to be implemented.

Signed-off-by: Farouk Bouabid <farouk.bouabid at theobroma-systems.com>
---
 Documentation/devicetree/bindings/serial/rs485.yaml | 5 +++++
 1 file changed, 5 insertions(+)

diff --git a/Documentation/devicetree/bindings/serial/rs485.yaml b/Documentation/devicetree/bindings/serial/rs485.yaml
index b64577036b5c..4c79dfaaf460 100644
--- a/Documentation/devicetree/bindings/serial/rs485.yaml
+++ b/Documentation/devicetree/bindings/serial/rs485.yaml
@@ -55,6 +55,11 @@ properties:
     description: GPIO to handle a separate RS485 receive enable signal
     maxItems: 1
 
+  rs485-rx-enable-inactive-when-rs485-disabled:
+    description: rx-enable GPIO is not active when RS485 is disabled. If missing, active-state
+      is assumed.
+    $ref: /schemas/types.yaml#/definitions/flag
+
   rs485-term-gpios:
     description: GPIO pin to enable RS485 bus termination.
     maxItems: 1

-- 
2.34.1




More information about the linux-arm-kernel mailing list