[PATCH v3 5/8] ARM: dts: microchip: sama5d27_wlsom1_ek: Add power-supply property for sdmmc0 node

[claudiu beznea]

On 06.02.2024 14:03, Mihai Sain wrote:
> The sdmmc0 controller is powered from 3.3V regulator.

Same here. SDMMC0 data lines are powered by VDDSDHC which could be 1v8/3v3.

[1]
https://ww1.microchip.com/downloads/aemDocuments/documents/MPU32/ProductDocuments/UserGuides/SAMA5D2-Wireless-SOM1-Kit-User%27s-Guide-50002931d.pdf

> Add vmmc-supply and vqmmc-supply properties to sdmmc0 node.
> The sdmmc controller from SAMA5D2 MPU has support for
> IO voltage signaling/switching required by the UHS sd-card.
> In order to avoid the issues from the tuning procedure required by
> the UHS cards, keep the vqmmc at 3V3 to use the sd high-speed mode.
> 
> Signed-off-by: Mihai Sain <mihai.sain at microchip.com>
> ---
>  arch/arm/boot/dts/microchip/at91-sama5d27_wlsom1_ek.dts | 2 ++
>  1 file changed, 2 insertions(+)
> 
> diff --git a/arch/arm/boot/dts/microchip/at91-sama5d27_wlsom1_ek.dts b/arch/arm/boot/dts/microchip/at91-sama5d27_wlsom1_ek.dts
> index 15239834d886..7b36e1970bb7 100644
> --- a/arch/arm/boot/dts/microchip/at91-sama5d27_wlsom1_ek.dts
> +++ b/arch/arm/boot/dts/microchip/at91-sama5d27_wlsom1_ek.dts
> @@ -199,6 +199,8 @@ &sdmmc0 {
>  	bus-width = <4>;
>  	pinctrl-names = "default";
>  	pinctrl-0 = <&pinctrl_sdmmc0_default>;
> +	vmmc-supply = <&vdd_3v3>;
> +	vqmmc-supply = <&vdd_3v3>;
>  	status = "okay";
>  };
>