[PATCH] ARM: multi_v7_defconfig: Select CONFIG_USB_ONBOARD_DEV as built-in

[Alexander Stein]

Hi,

Am Dienstag, 30. April 2024, 00:09:52 CEST schrieb Fabio Estevam:
> Hi Arnd,
> 
> On Mon, Apr 8, 2024 at 11:03 AM Fabio Estevam <festevam at gmail.com> wrote:
> >
> > From: Fabio Estevam <festevam at denx.de>
> >
> > Selecting CONFIG_USB_ONBOARD_DEV as a module may cause the following
> > run-time error when probing a USB2514 hub on a imx6q-udoo board:
> >
> > usb 1-1: device not accepting address 5, error -71
> > usb usb1-port1: unable to enumerate USB device
> >
> > Fix this issue by selecting CONFIG_USB_ONBOARD_DEV as built-in so
> > that the USB hub reset line and clock can be activated earlier.
> >
> > Signed-off-by: Fabio Estevam <festevam at denx.de>
> > ---
> > Here is the imx6q-udoo boot log from Mark's farm that shows the problem:
> >
> > https://storage.kernelci.org/next/master/next-20240408/arm/multi_v7_defconfig/gcc-10/lab-broonie/baseline-imx6dl-udoo.html
> 
> A gentle ping.

Despite the change to the defconfig. If this driver causes problems when
being built as module, shouldn't it be bool instead of tristate then?

Best regards,
Alexander

-- 
TQ-Systems GmbH | Mühlstraße 2, Gut Delling | 82229 Seefeld, Germany
Amtsgericht München, HRB 105018
Geschäftsführer: Detlef Schneider, Rüdiger Stahl, Stefan Schneider
http://www.tq-group.com/