[PATCH v2 3/4] PCI: imx6: Convert to agnostic GPIO API

[Frank Li]

On Tue, Apr 23, 2024 at 11:03:59PM +0300, Andy Shevchenko wrote:
> On Tue, Apr 23, 2024 at 03:56:56PM -0400, Frank Li wrote:
> > On Tue, Apr 23, 2024 at 08:19:06PM +0300, Andy Shevchenko wrote:
> 
> ...
> 
> > > +	imx6_pcie->reset_gpiod =
> > > +		devm_gpiod_get_optional(dev, "reset",
> > > +			imx6_pcie->gpio_active_high ? GPIOD_OUT_HIGH : GPIOD_OUT_LOW);
> > > +	if (IS_ERR(imx6_pcie->reset_gpiod))
> > > +		return dev_err_probe(dev, PTR_ERR(imx6_pcie->reset_gpiod),
> > > +				     "unable to get reset gpio\n");
> > 
> > Small problem here. err message "unable to get reset gpio\n" will print
> > when -EPROBE_DEFER happen. EPROBE_DEFER is quite common when use i2c
> > expand gpio chip.
> 
> I'm not sure how you come to this conclusion. Can you elaborate, please?
> P.S> I do not see a problem as described.

If i2c gpio-expander driver have not load when imx6_pcie probe, I supposed
devm_gpiod_get_optional() will return -EPROBE_DEFER, 

if (IS_ERR(imx6_pcie->reset_gpiod)) should be true. then dev_err_probe()
will run and print "unable to get reset gpio\n" with error code
-EPROBE_DEFER.

driver framework will retry imx6_pcie probe again when a new device appear.
it may retry sevial times utill i2c gpio-expander driver probe success or
timeout.

Frank

> 
> -- 
> With Best Regards,
> Andy Shevchenko
> 
>