[PATCH v4 06/13] drm: zynqmp_dp: Don't delay work
Sean Anderson
sean.anderson at linux.dev
Tue Apr 23 10:18:52 PDT 2024
We always call scheduled_delayed_work with no delay, so just use a
non-delayed work_struct instead.
Signed-off-by: Sean Anderson <sean.anderson at linux.dev>
Reviewed-by: Tomi Valkeinen <tomi.valkeinen at ideasonboard.com>
---
(no changes since v3)
Changes in v3:
- New
drivers/gpu/drm/xlnx/zynqmp_dp.c | 13 ++++++-------
1 file changed, 6 insertions(+), 7 deletions(-)
diff --git a/drivers/gpu/drm/xlnx/zynqmp_dp.c b/drivers/gpu/drm/xlnx/zynqmp_dp.c
index 6e8478d58b02..677db546169f 100644
--- a/drivers/gpu/drm/xlnx/zynqmp_dp.c
+++ b/drivers/gpu/drm/xlnx/zynqmp_dp.c
@@ -297,7 +297,7 @@ struct zynqmp_dp_config {
struct zynqmp_dp {
struct drm_dp_aux aux;
struct drm_bridge bridge;
- struct delayed_work hpd_work;
+ struct work_struct hpd_work;
struct drm_bridge *next_bridge;
struct device *dev;
@@ -1467,7 +1467,7 @@ static void zynqmp_dp_bridge_atomic_disable(struct drm_bridge *bridge,
struct zynqmp_dp *dp = bridge_to_dp(bridge);
dp->enabled = false;
- cancel_delayed_work(&dp->hpd_work);
+ cancel_work(&dp->hpd_work);
zynqmp_dp_write(dp, ZYNQMP_DP_MAIN_STREAM_ENABLE, 0);
drm_dp_dpcd_writeb(&dp->aux, DP_SET_POWER, DP_SET_POWER_D3);
zynqmp_dp_write(dp, ZYNQMP_DP_TX_PHY_POWER_DOWN,
@@ -1603,8 +1603,7 @@ void zynqmp_dp_disable_vblank(struct zynqmp_dp *dp)
static void zynqmp_dp_hpd_work_func(struct work_struct *work)
{
- struct zynqmp_dp *dp = container_of(work, struct zynqmp_dp,
- hpd_work.work);
+ struct zynqmp_dp *dp = container_of(work, struct zynqmp_dp, hpd_work);
enum drm_connector_status status;
status = zynqmp_dp_bridge_detect(&dp->bridge);
@@ -1640,7 +1639,7 @@ static irqreturn_t zynqmp_dp_irq_handler(int irq, void *data)
zynqmp_dpsub_drm_handle_vblank(dp->dpsub);
if (status & ZYNQMP_DP_INT_HPD_EVENT)
- schedule_delayed_work(&dp->hpd_work, 0);
+ schedule_work(&dp->hpd_work);
if (status & ZYNQMP_DP_INT_HPD_IRQ) {
int ret;
@@ -1682,7 +1681,7 @@ int zynqmp_dp_probe(struct zynqmp_dpsub *dpsub)
dp->dpsub = dpsub;
dp->status = connector_status_disconnected;
- INIT_DELAYED_WORK(&dp->hpd_work, zynqmp_dp_hpd_work_func);
+ INIT_WORK(&dp->hpd_work, zynqmp_dp_hpd_work_func);
/* Acquire all resources (IOMEM, IRQ and PHYs). */
res = platform_get_resource_byname(pdev, IORESOURCE_MEM, "dp");
@@ -1787,7 +1786,7 @@ void zynqmp_dp_remove(struct zynqmp_dpsub *dpsub)
zynqmp_dp_write(dp, ZYNQMP_DP_INT_DS, ZYNQMP_DP_INT_ALL);
disable_irq(dp->irq);
- cancel_delayed_work_sync(&dp->hpd_work);
+ cancel_work_sync(&dp->hpd_work);
zynqmp_dp_write(dp, ZYNQMP_DP_TRANSMITTER_ENABLE, 0);
zynqmp_dp_write(dp, ZYNQMP_DP_INT_DS, 0xffffffff);
--
2.35.1.1320.gc452695387.dirty
More information about the linux-arm-kernel
mailing list