[PATCH 08/20] ARM: dts: stm32: Add alternate pinmux for MP13 MCAN2 pins

[Marek Vasut]

Add another mux option for MCAN2 pins, this is used on
DH electronics STM32MP13xx DHCOR DHSBC board.

Signed-off-by: Marek Vasut <marex at denx.de>
---
Cc: "Leonard Göhrs" <l.goehrs at pengutronix.de>
Cc: Ahmad Fatoum <a.fatoum at pengutronix.de>
Cc: Alexandre Torgue <alexandre.torgue at foss.st.com>
Cc: Andre Przywara <andre.przywara at arm.com>
Cc: Conor Dooley <conor+dt at kernel.org>
Cc: Dario Binacchi <dario.binacchi at amarulasolutions.com>
Cc: Krzysztof Kozlowski <krzk+dt at kernel.org>
Cc: Linus Walleij <linus.walleij at linaro.org>
Cc: Maxime Coquelin <mcoquelin.stm32 at gmail.com>
Cc: Rob Herring <robh at kernel.org>
Cc: Sean Nyekjaer <sean at geanix.com>
Cc: Steffen Trumtrar <s.trumtrar at pengutronix.de>
Cc: devicetree at vger.kernel.org
Cc: kernel at dh-electronics.com
Cc: linux-arm-kernel at lists.infradead.org
Cc: linux-stm32 at st-md-mailman.stormreply.com
---
 arch/arm/boot/dts/st/stm32mp13-pinctrl.dtsi | 20 ++++++++++++++++++++
 1 file changed, 20 insertions(+)

diff --git a/arch/arm/boot/dts/st/stm32mp13-pinctrl.dtsi b/arch/arm/boot/dts/st/stm32mp13-pinctrl.dtsi
index b38174504fffa..b58bf6c00244c 100644
--- a/arch/arm/boot/dts/st/stm32mp13-pinctrl.dtsi
+++ b/arch/arm/boot/dts/st/stm32mp13-pinctrl.dtsi
@@ -188,6 +188,26 @@ pins {
 		};
 	};
 
+	m_can2_pins_a: m-can2-0 {
+		pins1 {
+			pinmux = <STM32_PINMUX('G', 0, AF9)>; /* CAN2_TX */
+			slew-rate = <1>;
+			drive-push-pull;
+			bias-disable;
+		};
+		pins2 {
+			pinmux = <STM32_PINMUX('E', 0, AF9)>; /* CAN2_RX */
+			bias-disable;
+		};
+	};
+
+	m_can2_sleep_pins_a: m_can2-sleep-0 {
+		pins {
+			pinmux = <STM32_PINMUX('G', 0, ANALOG)>, /* CAN2_TX */
+				 <STM32_PINMUX('E', 0, ANALOG)>; /* CAN2_RX */
+		};
+	};
+
 	mcp23017_pins_a: mcp23017-0 {
 		pins {
 			pinmux = <STM32_PINMUX('G', 12, GPIO)>;
-- 
2.43.0