[PATCH v11 2/4] dt-bindings: firmware: arm,scmi: support pinctrl protocol

[Peng Fan (OSS)]

From: Peng Fan <peng.fan at nxp.com>

Add SCMI v3.2 pinctrl protocol bindings and example.

Reviewed-by: Rob Herring <robh at kernel.org>
Reviewed-by: Linus Walleij <linus.walleij at linaro.org>
Reviewed-by: Dhruva Gole <d-gole at ti.com>
Signed-off-by: Peng Fan <peng.fan at nxp.com>
---
 .../devicetree/bindings/firmware/arm,scmi.yaml     | 50 ++++++++++++++++++++++
 1 file changed, 50 insertions(+)

diff --git a/Documentation/devicetree/bindings/firmware/arm,scmi.yaml b/Documentation/devicetree/bindings/firmware/arm,scmi.yaml
index 93fb7d05f849..7de2c29606e5 100644
--- a/Documentation/devicetree/bindings/firmware/arm,scmi.yaml
+++ b/Documentation/devicetree/bindings/firmware/arm,scmi.yaml
@@ -247,6 +247,37 @@ properties:
       reg:
         const: 0x18
 
+  protocol at 19:
+    type: object
+    allOf:
+      - $ref: '#/$defs/protocol-node'
+      - $ref: /schemas/pinctrl/pinctrl.yaml
+
+    unevaluatedProperties: false
+
+    properties:
+      reg:
+        const: 0x19
+
+    patternProperties:
+      '-pins$':
+        type: object
+        allOf:
+          - $ref: /schemas/pinctrl/pincfg-node.yaml#
+          - $ref: /schemas/pinctrl/pinmux-node.yaml#
+        unevaluatedProperties: false
+
+        description:
+          A pin multiplexing sub-node describes how to configure a
+          set of pins in some desired function.
+          A single sub-node may define several pin configurations.
+          This sub-node is using the default pinctrl bindings to configure
+          pin multiplexing and using SCMI protocol to apply a specified
+          configuration.
+
+    required:
+      - reg
+
 additionalProperties: false
 
 $defs:
@@ -401,6 +432,25 @@ examples:
             scmi_powercap: protocol at 18 {
                 reg = <0x18>;
             };
+
+            scmi_pinctrl: protocol at 19 {
+                reg = <0x19>;
+
+                i2c2-pins {
+                    groups = "g_i2c2_a", "g_i2c2_b";
+                    function = "f_i2c2";
+                };
+
+                mdio-pins {
+                    groups = "g_avb_mdio";
+                    drive-strength = <24>;
+                };
+
+                keys_pins: keys-pins {
+                    pins = "gpio_5_17", "gpio_5_20", "gpio_5_22", "gpio_2_1";
+                    bias-pull-up;
+                };
+            };
         };
     };
 

-- 
2.37.1