[PATCH v3 12/25] media: i2c: imx258: Allow configuration of clock lane behaviour

[Luigi311]

On 4/3/24 12:48, Pavel Machek wrote:
> Hi!
> 
>> The sensor supports the clock lane either remaining in HS mode
>> during frame blanking, or dropping to LP11.
>>
>> Add configuration of the mode via V4L2_MBUS_CSI2_NONCONTINUOUS_CLOCK.
> 
>> +	ret = imx258_write_reg(imx258, IMX258_CLK_BLANK_STOP,
>> +			       IMX258_REG_VALUE_08BIT,
>> +			       imx258->csi2_flags & V4L2_MBUS_CSI2_NONCONTINUOUS_CLOCK ?
>> +			       1 : 0);
> 
> !! can be used to turn value into 1/0. I find it easier to read than ?
> 1 : 0  combination, but possibly that's fine, too.
> 
> Best regards,
> 								Pavel
> 

I assume you mean by using 

!!(imx258->csi2_flags & V4L2_MBUS_CSI2_NONCONTINUOUS_CLOCK)

I can go ahead and use that instead