[PATCH v2] arm64: dts: debix-a: Disable i2c2 in base .dts

[Marco Felsch]

On 24-04-04, Laurent Pinchart wrote:
> From: Jacopo Mondi <jacopo at jmondi.org>
> 
> The I2C2 bus is used for the CSI and DSI connectors only, no devices are
> connected to it on neither the Debix Model A nor its IO board. Disable
> the bus in the board's .dts and remove its clock frequency settings, as
> the value depends solely on the devices conncted to the CSI and DSI
> connectors. Display panel or camera sensor overlays will configure and
> enable the bus when necessary.
> 
> Signed-off-by: Jacopo Mondi <jacopo at jmondi.org>
> Signed-off-by: Laurent Pinchart <laurent.pinchart at ideasonboard.com>
> Reviewed-by: Kieran Bingham <kieran.bingham at ideasonboard.com>

Reviewed-by: Marco Felsch <m.felsch at pengutronix.de>