[PATCH v3 19/25] media: i2c: imx258: Change register settings for variants of the sensor

[Sakari Ailus]

Hi Luis, Dave,

On Wed, Apr 03, 2024 at 09:03:48AM -0600, git at luigi311.com wrote:
> From: Dave Stevenson <dave.stevenson at raspberrypi.com>
> 
> Sony have advised that there are variants of the IMX258 sensor which
> require slightly different register configuration to the mainline
> imx258 driver defaults.
> 
> There is no available run-time detection for the variant, so add
> configuration via the DT compatible string.
> 
> The Vision Components imx258 module supports PDAF, so add the
> register differences for that variant
> 
> Signed-off-by: Dave Stevenson <dave.stevenson at raspberrypi.com>
> Signed-off-by: Luis Garcia <git at luigi311.com>
> ---
>  drivers/media/i2c/imx258.c | 48 ++++++++++++++++++++++++++++++++++----
>  1 file changed, 44 insertions(+), 4 deletions(-)
> 
> diff --git a/drivers/media/i2c/imx258.c b/drivers/media/i2c/imx258.c
> index 775d957c9b87..fa48da212037 100644
> --- a/drivers/media/i2c/imx258.c
> +++ b/drivers/media/i2c/imx258.c
> @@ -6,6 +6,7 @@
>  #include <linux/delay.h>
>  #include <linux/i2c.h>
>  #include <linux/module.h>
> +#include <linux/of_device.h>
>  #include <linux/pm_runtime.h>
>  #include <linux/regulator/consumer.h>
>  #include <media/v4l2-ctrls.h>
> @@ -321,8 +322,6 @@ static const struct imx258_reg mipi_642mbps_24mhz_4l[] = {
>  
>  static const struct imx258_reg mode_common_regs[] = {
>  	{ 0x3051, 0x00 },
> -	{ 0x3052, 0x00 },
> -	{ 0x4E21, 0x14 },
>  	{ 0x6B11, 0xCF },
>  	{ 0x7FF0, 0x08 },
>  	{ 0x7FF1, 0x0F },
> @@ -345,7 +344,6 @@ static const struct imx258_reg mode_common_regs[] = {
>  	{ 0x7FA8, 0x03 },
>  	{ 0x7FA9, 0xFE },
>  	{ 0x7B24, 0x81 },
> -	{ 0x7B25, 0x00 },
>  	{ 0x6564, 0x07 },
>  	{ 0x6B0D, 0x41 },
>  	{ 0x653D, 0x04 },
> @@ -460,6 +458,33 @@ static const struct imx258_reg mode_1048_780_regs[] = {
>  	{ 0x034F, 0x0C },
>  };
>  
> +struct imx258_variant_cfg {
> +	const struct imx258_reg *regs;
> +	unsigned int num_regs;
> +};
> +
> +static const struct imx258_reg imx258_cfg_regs[] = {
> +	{ 0x3052, 0x00 },
> +	{ 0x4E21, 0x14 },
> +	{ 0x7B25, 0x00 },
> +};
> +
> +static const struct imx258_variant_cfg imx258_cfg = {
> +	.regs = imx258_cfg_regs,
> +	.num_regs = ARRAY_SIZE(imx258_cfg_regs),
> +};
> +
> +static const struct imx258_reg imx258_pdaf_cfg_regs[] = {
> +	{ 0x3052, 0x01 },
> +	{ 0x4E21, 0x10 },
> +	{ 0x7B25, 0x01 },
> +};
> +
> +static const struct imx258_variant_cfg imx258_pdaf_cfg = {
> +	.regs = imx258_pdaf_cfg_regs,
> +	.num_regs = ARRAY_SIZE(imx258_pdaf_cfg_regs),
> +};
> +
>  static const char * const imx258_test_pattern_menu[] = {
>  	"Disabled",
>  	"Solid Colour",
> @@ -637,6 +662,8 @@ struct imx258 {
>  	struct v4l2_subdev sd;
>  	struct media_pad pad;
>  
> +	const struct imx258_variant_cfg *variant_cfg;
> +
>  	struct v4l2_ctrl_handler ctrl_handler;
>  	/* V4L2 Controls */
>  	struct v4l2_ctrl *link_freq;
> @@ -1104,6 +1131,14 @@ static int imx258_start_streaming(struct imx258 *imx258)
>  		return ret;
>  	}
>  
> +	ret = imx258_write_regs(imx258, imx258->variant_cfg->regs,
> +				imx258->variant_cfg->num_regs);
> +	if (ret) {
> +		dev_err(&client->dev, "%s failed to set variant config\n",
> +			__func__);
> +		return ret;
> +	}
> +
>  	ret = imx258_write_reg(imx258, IMX258_CLK_BLANK_STOP,
>  			       IMX258_REG_VALUE_08BIT,
>  			       imx258->csi2_flags & V4L2_MBUS_CSI2_NONCONTINUOUS_CLOCK ?
> @@ -1492,6 +1527,10 @@ static int imx258_probe(struct i2c_client *client)
>  
>  	imx258->csi2_flags = ep.bus.mipi_csi2.flags;
>  
> +	imx258->variant_cfg = of_device_get_match_data(&client->dev);

You'll also need to keep this working for ACPI based systems. I.e. in
practice remove "of_" prefix here and add the non-PDAF variant data to the
relevant ACPI ID list.

> +	if (!imx258->variant_cfg)
> +		imx258->variant_cfg = &imx258_cfg;
> +
>  	/* Initialize subdev */
>  	v4l2_i2c_subdev_init(&imx258->sd, client, &imx258_subdev_ops);
>  
> @@ -1579,7 +1618,8 @@ MODULE_DEVICE_TABLE(acpi, imx258_acpi_ids);
>  #endif
>  
>  static const struct of_device_id imx258_dt_ids[] = {
> -	{ .compatible = "sony,imx258" },
> +	{ .compatible = "sony,imx258", .data = &imx258_cfg },
> +	{ .compatible = "sony,imx258-pdaf", .data = &imx258_pdaf_cfg },
>  	{ /* sentinel */ }
>  };
>  MODULE_DEVICE_TABLE(of, imx258_dt_ids);

-- 
Kind regards,

Sakari Ailus