[PATCH 2/2] arm64: dts: ti: k3-am642-phyboard-electra-rdk: Increase CAN max bitrate

[Nishanth Menon]

On 11:12-20240402, Nishanth Menon wrote:
> On 09:08-20240402, Nathan Morrisson wrote:
> > The phyBOARD-Electra has two TCAN1044VDD CAN transceivers which
> > support CAN FD at 8 Mbps.
> > 
> > Increase the maximum bitrate to 8 Mbps.
> > 
> > Signed-off-by: Nathan Morrisson <nmorrisson at phytec.com>
> > ---
> >  arch/arm64/boot/dts/ti/k3-am642-phyboard-electra-rdk.dts | 4 ++--
> >  1 file changed, 2 insertions(+), 2 deletions(-)
> > 
> > diff --git a/arch/arm64/boot/dts/ti/k3-am642-phyboard-electra-rdk.dts b/arch/arm64/boot/dts/ti/k3-am642-phyboard-electra-rdk.dts
> > index 8237b8c815b8..522699ec65e8 100644
> > --- a/arch/arm64/boot/dts/ti/k3-am642-phyboard-electra-rdk.dts
> > +++ b/arch/arm64/boot/dts/ti/k3-am642-phyboard-electra-rdk.dts
> > @@ -42,7 +42,7 @@ can_tc1: can-phy0 {
> >  		pinctrl-names = "default";
> >  		pinctrl-0 = <&can_tc1_pins_default>;
> >  		#phy-cells = <0>;
> > -		max-bitrate = <5000000>;
> > +		max-bitrate = <8000000>;
> >  		standby-gpios = <&main_gpio0 32 GPIO_ACTIVE_HIGH>;
> >  	};
> >  
> > @@ -51,7 +51,7 @@ can_tc2: can-phy1 {
> >  		pinctrl-names = "default";
> >  		pinctrl-0 = <&can_tc2_pins_default>;
> >  		#phy-cells = <0>;
> > -		max-bitrate = <5000000>;
> > +		max-bitrate = <8000000>;
> >  		standby-gpios = <&main_gpio0 35 GPIO_ACTIVE_HIGH>;
> >  	};
> >  
> > -- 
> > 2.25.1
> > 
> 



> This is better at arch/arm64/boot/dts/ti/k3-am62p-main.dtsi.
> 

Woops.. wrong mail thread. :( Apologies on the spam.
-- 
Regards,
Nishanth Menon
Key (0xDDB5849D1736249D) / Fingerprint: F8A2 8693 54EB 8232 17A3  1A34 DDB5 849D 1736 249D