[PATCH 3/3] arm64: dts: ti: k3-am68-sk: Add DT node for USB

[Ravi Gunasekaran]

From: Sinthu Raja <sinthu.raja at ti.com>

AM68 Starter kit has a USB3 hub that connects to the SerDes0 Lane 2.
Update the SerDes configuration to support USB3.

Signed-off-by: Sinthu Raja <sinthu.raja at ti.com>
Signed-off-by: Ravi Gunasekaran <r-gunasekaran at ti.com>
---
 .../boot/dts/ti/k3-am68-sk-base-board.dts     | 27 +++++++++++++++++++
 1 file changed, 27 insertions(+)

diff --git a/arch/arm64/boot/dts/ti/k3-am68-sk-base-board.dts b/arch/arm64/boot/dts/ti/k3-am68-sk-base-board.dts
index 81c2307c77f9..1e1a82f9d2b8 100644
--- a/arch/arm64/boot/dts/ti/k3-am68-sk-base-board.dts
+++ b/arch/arm64/boot/dts/ti/k3-am68-sk-base-board.dts
@@ -573,6 +573,15 @@
 		cdns,phy-type = <PHY_TYPE_PCIE>;
 		resets = <&serdes_wiz0 1>, <&serdes_wiz0 2>;
 	};
+
+	serdes0_usb_link: phy at 2 {
+		status = "okay";
+		reg = <2>;
+		cdns,num-lanes = <1>;
+		#phy-cells = <0>;
+		cdns,phy-type = <PHY_TYPE_USB3>;
+		resets = <&serdes_wiz0 3>;
+	};
 };
 
 &pcie1_rc {
@@ -582,3 +591,21 @@
 	phy-names = "pcie-phy";
 	num-lanes = <2>;
 };
+
+&usb_serdes_mux {
+	idle-states = <0>; /* USB0 to SERDES lane 2 */
+};
+
+&usbss0 {
+	status = "okay";
+	pinctrl-0 = <&main_usbss0_pins_default>;
+	pinctrl-names = "default";
+	ti,vbus-divider;
+};
+
+&usb0 {
+	dr_mode = "host";
+	maximum-speed = "super-speed";
+	phys = <&serdes0_usb_link>;
+	phy-names = "cdns3,usb3-phy";
+};
-- 
2.17.1