[PATCH 22/37] clk: renesas: add minimal boot support for RZ/G3S SoC

[claudiu beznea]

Hi, Geert,

On 15.09.2023 15:52, Geert Uytterhoeven wrote:
> Hi Claudiu,
> 
> On Tue, Sep 12, 2023 at 6:53 AM Claudiu <claudiu.beznea at tuxon.dev> wrote:
>> From: Claudiu Beznea <claudiu.beznea.uj at bp.renesas.com>
>>
>> Add minimal clock and reset support for RZ/G3S SoC to be able to boot
>> Linux from SD Card/eMMC. This includes necessary core clocks for booting
>> and GIC, SCIF, GPIO, SD0 mod clocks and resets.
>>
>> Signed-off-by: Claudiu Beznea <claudiu.beznea.uj at bp.renesas.com>
> 
> Thanks for your patch!
> 

[ ... ]

>> +       CLK_PLL3_DIV2_4,
>> +       CLK_PLL3_DIV2_8,
>> +       CLK_PLL3_DIV6,
>> +       CLK_PLL4,
>> +       CLK_PLL6,
>> +       CLK_PLL6_DIV2,
>> +       CLK_SEL_SDHI0,
>> +       CLK_SEL_PLL4,
>> +       CLK_P1_DIV2,
>> +       CLK_P3_DIV2,
> 
> Do you need CLK_P1_DIV2 and CLK_P3_DIV2?
> I don't see them in Figure 7.3 ("Clock System Diagram (2)").
> 

P1_DIV2 is clock source for MHU_PCLK or OTFDE_DDR_PCLK.
P3_DIV2 is clock source for DMAC_PCLK, OTFDE_SPI_PCLK.
These are expressed in clock list document
(RZG3S_clock_list_r1.00_20230602.xlsx).

It is true the functionality could be preserved even w/o these 2 clocks but
I kept them here as I saw them as core clocks even though they are not
present in the Clock System Diagram from HW manual.

With these, would you prefer to keep these clocks or just remove them?

Thank you,
Claudiu Beznea