[PATCH 1/2] arm64: dts: marvell: uDPU: rename the SFP GPIO properties

[Robert Marko]

Rename the GPIO related SFP properties to include the preffered -gpios
suffix as defined in the SFP schema.

This fixes the following warning:
arch/arm64/boot/dts/marvell/armada-3720-eDPU.dtb: sfp-eth1: 'los-gpio', 'mod-def0-gpio', 'tx-disable-gpio', 'tx-fault-gpio' do not match any of the regexes: 'pinctrl-[0-9]+'
from schema $id: http://devicetree.org/schemas/net/sff,sfp.yaml#

Signed-off-by: Robert Marko <robert.marko at sartura.hr>
---
 arch/arm64/boot/dts/marvell/armada-3720-uDPU.dtsi | 8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/arch/arm64/boot/dts/marvell/armada-3720-uDPU.dtsi b/arch/arm64/boot/dts/marvell/armada-3720-uDPU.dtsi
index 3f79923376fb..3a9b6907185d 100644
--- a/arch/arm64/boot/dts/marvell/armada-3720-uDPU.dtsi
+++ b/arch/arm64/boot/dts/marvell/armada-3720-uDPU.dtsi
@@ -61,10 +61,10 @@ led-alarm2 {
 	sfp_eth1: sfp-eth1 {
 		compatible = "sff,sfp";
 		i2c-bus = <&i2c1>;
-		los-gpio = <&gpiosb 7 GPIO_ACTIVE_HIGH>;
-		mod-def0-gpio = <&gpiosb 8 GPIO_ACTIVE_LOW>;
-		tx-disable-gpio = <&gpiosb 9 GPIO_ACTIVE_HIGH>;
-		tx-fault-gpio = <&gpiosb 10 GPIO_ACTIVE_HIGH>;
+		los-gpios = <&gpiosb 7 GPIO_ACTIVE_HIGH>;
+		mod-def0-gpios = <&gpiosb 8 GPIO_ACTIVE_LOW>;
+		tx-disable-gpios = <&gpiosb 9 GPIO_ACTIVE_HIGH>;
+		tx-fault-gpios = <&gpiosb 10 GPIO_ACTIVE_HIGH>;
 		maximum-power-milliwatt = <3000>;
 	};
 };
-- 
2.41.0