[PATCH 1/3] media: rc: meson-ir: support rc driver type RC_DRIVER_SCANCODE

[neil.armstrong at linaro.org]

On 06/09/2023 09:11, Zelong Dong wrote:
> 
> 
> 在 2023/8/25 20:19, Neil Armstrong 写道:
>> On 25/08/2023 13:53, zelong dong wrote:
>>> From: Zelong Dong <zelong.dong at amlogic.com>
>>>
>>> Meson IR Controller supports hardware decoder in Meson-S4 and later
>>> SoC. So far, protocol NEC could be decoded by hardware decoder.
>>>
>>> Signed-off-by: Zelong Dong <zelong.dong at amlogic.com>
>>> ---
>>>   drivers/media/rc/meson-ir.c | 522 +++++++++++++++++++++++++++++++-----
>>>   1 file changed, 451 insertions(+), 71 deletions(-)
>>>
>>
>> <snip>
>>
>> It looks pretty good now, so far I'm ok with it:
>>
>> Reviewed-by: Neil Armstrong <neil.armstrong at linaro.org>
>>
>> I think some test reports would be needed to be sure it doesn't regress existing HW.
>>
>> Thanks,
>> Neil
> 
> Sorry for my late reply, I spent a long time looking for development boards.
> I searched Meson-IR DT Node from all the Amlogic DT, only 4 DTSI as follow:
> arch/arm64/boot/dts/amlogic/meson-g12-common.dtsi
> arch/arm64/boot/dts/amlogic/meson-axg.dtsi
> arch/arm64/boot/dts/amlogic/meson-gx.dtsi
> arch/arm/boot/dts/amlogic/meson.dtsi
> 
> So I planned to sample the boards to test:
> arch/arm64/boot/dts/amlogic/meson-g12a-u200.dts
> arch/arm64/boot/dts/amlogic/meson-axg-s400.dts
> arch/arm64/boot/dts/amlogic/meson-gxl-s905x-p212.dts
> arch/arm/boot/dts/amlogic/meson8b-odroidc1.dts
> 
> Unfortunately, meson-gxl-s905x-p212 & meson8b-odroidc1 are too old to be find.
> there are only 2 boards I got, meson-g12a-u200 & meson-axg-s400, and they worked.
> 
> [    0.943097] IR NEC protocol handler initialized
> [    0.943146] IR RC5(x/sz) protocol handler initialized
> [    0.947029] IR RC6 protocol handler initialized
> [    0.951508] IR RCMM protocol handler initialized
> [    0.956080] IR XMP protocol handler initialized
> [    0.961266] Registered IR keymap rc-empty
> [    0.964674] rc rc0: meson-ir as /devices/platform/soc/ff800000.bus/ff808000.ir/rc/rc0
> [    0.972437] input: meson-ir as /devices/platform/soc/ff800000.bus/ff808000.ir/rc/rc0/input0
> [    0.980983] rc rc0: sw decoder init
> [    0.984089] meson-ir ff808000.ir: receiver initialized
> 
> # cd /sys/devices/platform/soc/ff800000.bus/ff808000.ir/rc/rc0/
> # cat protocols
> rc-5 nec rc-6 rc-5-sz xmp rc-mm
> # echo nec > protocols
> # hexdump /dev/input/event0
> 0000000 0069 0000 3180 0005 0004 0004 011b 0000
> 0000010 0069 0000 3180 0005 0000 0000 0000 0000
> 0000020 0069 0000 fc80 0005 0004 0004 011b 0000
> 0000030 0069 0000 fc80 0005 0000 0000 0000 0000
> 0000040 0069 0000 92db 0007 0004 0004 011b 0000
> 0000050 0069 0000 92db 0007 0000 0000 0000 0000
> 0000060 0069 0000 388b 0009 0004 0004 011b 0000
> 0000070 0069 0000 388b 0009 0000 0000 0000 0000
> 0000080 0069 0000 de72 000a 0004 0004 011b 0000
> 0000090 0069 0000 de72 000a 0000 0000 0000 0000

It's fine !

Thanks for testing !!

Neil