[PATCH v6 2/5] PCI: brcmstb: Configure HW CLKREQ# mode appropriate for downstream device
Sam Edwards
cfsworks at gmail.com
Tue Sep 5 13:24:50 PDT 2023
On 6/23/23 08:40, Jim Quinlan wrote:
Hi Jim,
As I understand, the issue that this patch fixes can be difficult to
trigger reliably. So I'll report that the abort occurs 100% of the time
on a Compute Module 4, installed in slot 3 of a Turing Pi 2 cluster
board, when a bootloader (U-Boot, in my case) is in the boot path. The
third slot of the TP2 board connects to an ASM1061 chip with the CLKREQ#
line left floating. I do not know why the bootloader is necessary for
the crash to occur; I suspect it's timing-related.
With this patch applied to my kernel, my observed crash rate goes from
100% to 0%, so:
> Signed-off-by: Jim Quinlan <james.quinlan at broadcom.com>
> Tested-by: Florian Fainelli <f.fainelli at gmail.com>
> Tested-by: Cyril Brulebois <cyril at debamax.com>
Tested-by: Sam Edwards <CFSworks at gmail.com>
Many thanks,
Sam
More information about the linux-arm-kernel
mailing list