[PATCH] mmc: mmci: stm32: add SDIO in-band interrupt mode

[Linus Walleij]

Hi Yann/Christophe,

just a quick note:

On Fri, Sep 1, 2023 at 2:08 PM Yann Gautier <yann.gautier at foss.st.com> wrote:

> +static void sdmmc_enable_sdio_irq(struct mmci_host *host, int enable)
> +{
> +       void __iomem *base = host->base;
> +       u32 mask = readl_relaxed(base + MMCIMASK0);
> +
> +       if (enable)
> +               writel_relaxed(mask | MCI_ST_SDIOITMASK, base + MMCIMASK0);
> +       else
> +               writel_relaxed(mask & ~MCI_ST_SDIOITMASK, base + MMCIMASK0);
> +}
> +
> +static void sdmmc_sdio_irq(struct mmci_host *host, u32 status)
> +{
> +       if (status & MCI_ST_SDIOIT) {
> +               sdmmc_enable_sdio_irq(host, 0);
> +               sdio_signal_irq(host->mmc);
> +       }
> +}

You need to move these to mmci and rename them since Ux500 will use
the same callbacks.

>  static struct mmci_host_ops sdmmc_variant_ops = {
>         .validate_data = sdmmc_idma_validate_data,
(...)
> +       .enable_sdio_irq = sdmmc_enable_sdio_irq,
> +       .sdio_irq = sdmmc_sdio_irq,
>  };

What about dropping the per-variant callbacks and just inline
this into mmci_enable_sdio_irq()/mmci_ack_sdio_irq() since
so many variants have the same scheme? I haven't looked
at the Qualcomm variant though, maybe it is completely
different...

Yours,
Linus Walleij