[RFC v5 5/5] dt-bindings: firmware: arm,scmi: Add support for pinctrl protocol

[Krzysztof Kozlowski]

On 27/10/2023 08:28, Oleksii Moisieiev wrote:
> Add new SCMI v3.2 pinctrl protocol bindings definitions and example.
> 
> Signed-off-by: Oleksii Moisieiev <oleksii_moisieiev at epam.com>
> 
> ---
> Changes v3 -> v4
>   - reworked protocol at 19 format
> ---
>  .../bindings/firmware/arm,scmi.yaml           | 53 +++++++++++++++++++
>  1 file changed, 53 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/firmware/arm,scmi.yaml b/Documentation/devicetree/bindings/firmware/arm,scmi.yaml
> index 5824c43e9893..5318fe72354e 100644
> --- a/Documentation/devicetree/bindings/firmware/arm,scmi.yaml
> +++ b/Documentation/devicetree/bindings/firmware/arm,scmi.yaml
> @@ -233,6 +233,39 @@ properties:
>        reg:
>          const: 0x18
>  
> +  protocol at 19:
> +    type: object
> +    allOf:
> +      - $ref: "#/$defs/protocol-node"
> +      - $ref: "../pinctrl/pinctrl.yaml"

This is a friendly reminder during the review process.

It seems my previous comments were not fully addressed. Maybe my
feedback got lost between the quotes, maybe you just forgot to apply it.
Please go back to the previous discussion and either implement all
requested changes or keep discussing them.

Thank you.


It does not look like you tested the bindings, at least after quick
look. Please run `make dt_binding_check` (see
Documentation/devicetree/bindings/writing-schema.rst for instructions).
Maybe you need to update your dtschema and yamllint.


Best regards,
Krzysztof