[PATCH v2 3/4] arm64: dts: nuvoton: Add pinctrl support for ma35d1

[Jacky Huang]

Dear Krzysztof,

Thanks for your review.


On 2023/11/28 下午 03:35, Krzysztof Kozlowski wrote:
> On 28/11/2023 07:11, Jacky Huang wrote:
>> From: Jacky Huang <ychuang3 at nuvoton.com>
>>
>> Add 'pinctrl' node and 'gpioa' ~ 'gpion' nodes to the dtsi of ma35d1
>> SoC and describe default pin configurations.
>>
>> Enable all UART nodes presented on som and iot boards, and add pinctrl
>> function settings to these nodes.
>>
>> Signed-off-by: Jacky Huang <ychuang3 at nuvoton.com>
>
>> +
>> +			gpion: gpio at 40040340 {
>> +				reg = <0x340 0x40>;
>> +				interrupts = <GIC_SPI  105 IRQ_TYPE_LEVEL_HIGH>;
>> +				clocks = <&clk GPN_GATE>;
>> +				gpio-controller;
>> +				#gpio-cells = <2>;
>> +				interrupt-controller;
>> +				#interrupt-cells = <2>;
>> +			};
>> +
>> +			pcfg_default: pin-default {
>> +				slew-rate = <0>;
>> +				input-schmitt-disable;
>> +				bias-disable;
>> +				power-source = <1>;
>> +				drive-strength = <17100>;
>> +			};
> It does not look like you tested the DTS against bindings. Please run
> `make dtbs_check W=1` (see
> Documentation/devicetree/bindings/writing-schema.rst or
> https://www.linaro.org/blog/tips-and-tricks-for-validating-devicetree-sources-with-the-devicetree-schema/
> for instructions).
>
> Best regards,
> Krzysztof
>

I forgot to remove 'ma35d1-pinfunc.h' from my local copy.
After remove the '#include <dt-bindings/pinctrl/ma35d1-pinfunc.h>', it 
can pass
the `make dtbs_check W=1` check.
I will fix it in the next version.


Best Regards,
Jacky Huang