[net-next PATCH RFC v3 6/8] dt-bindings: net: Document Qcom QCA807x PHY package

Andrew Lunn andrew at lunn.ch
Mon Nov 27 16:30:08 PST 2023


> +$ref: ethernet-phy-package.yaml#
> +
> +properties:
> +  qcom,package-mode:
> +    enum:
> +      - qsgmii
> +      - psgmii
> +
> +  qcom,tx-driver-strength:
> +    description: set the TX Amplifier value in mv.
> +      If not defined, 600mw is set by default.
> +    $ref: /schemas/types.yaml#/definitions/uint32
> +    enum: [140, 160, 180, 200, 220,
> +           240, 260, 280, 300, 320,
> +           400, 500, 600]

This is O.K, you are describing package properties, even if i don't
agree about qcom,package-mode.

> +patternProperties:
> +  ^ethernet-phy(@[a-f0-9]+)?$:
> +    $ref: ethernet-phy.yaml#
> +
> +    properties:
> +      gpio-controller:
> +        description: set the output lines as GPIO instead of LEDs
> +        type: boolean
> +
> +      '#gpio-cells':
> +        description: number of GPIO cells for the PHY
> +        const: 2

But now you are describing PHY properties. These belong on a .yaml of
its own, just like qca,ar803x.yaml defines properties for the AR803x
PHY.

	Andrew



More information about the linux-arm-kernel mailing list