[PATCH v2] arm64: dts: ti: k3-am625-beagleplay: Use UART name in pinmux name

[Andrew Davis]

The main_uart0 may not always be the console, but it will always be
the UART0 in MAIN domain. Name the pinmux node to match. This makes
it consistent with all other TI SoC based boards.

Signed-off-by: Andrew Davis <afd at ti.com>
---

Changes for v2:
 - Update node name to -pins postfix
 - Rebase on v6.7-rc1

 arch/arm64/boot/dts/ti/k3-am625-beagleplay.dts | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/arch/arm64/boot/dts/ti/k3-am625-beagleplay.dts b/arch/arm64/boot/dts/ti/k3-am625-beagleplay.dts
index 9a6bd0a3c94f7..eadbdd9ffe377 100644
--- a/arch/arm64/boot/dts/ti/k3-am625-beagleplay.dts
+++ b/arch/arm64/boot/dts/ti/k3-am625-beagleplay.dts
@@ -443,7 +443,7 @@ AM62X_IOPAD(0x01a8, PIN_INPUT, 7) /* (D20) MCASP0_AFSX.GPIO1_12 */
 		>;
 	};
 
-	console_pins_default: console-default-pins {
+	main_uart0_pins_default: main-uart0-default-pins {
 		bootph-all;
 		pinctrl-single,pins = <
 			AM62X_IOPAD(0x01c8, PIN_INPUT, 0) /* (D14) UART0_RXD */
@@ -877,7 +877,7 @@ wlcore: wlcore at 2 {
 &main_uart0 {
 	bootph-all;
 	pinctrl-names = "default";
-	pinctrl-0 = <&console_pins_default>;
+	pinctrl-0 = <&main_uart0_pins_default>;
 	status = "okay";
 };
 
-- 
2.39.2