[PATCH 0/3] ARM: dts: bcm2711-rpi-cm4-io: Enable xHCI host

[Stefan Wahren]

Hi Cyril,

Am 27.11.23 um 14:02 schrieb Cyril Brulebois:
> Stefan Wahren <wahrenst at gmx.net> (2023-11-27):
>> Could you please provide the following information:
>>
>> - settings of config.txt
> Here you go:
>
>      arm_64bit=1
>      enable_uart=1
>      upstream_kernel=1
>
>      kernel=vmlinuz-6.6.0+
>      initramfs initrd.img-6.6.0+
>
>      enable_jtag_gpio=1
>      force_turbo=1
>
>> - VC firmware version
> This is pieeprom-2023-01-11.bin
>
> I know there's pieeprom-2023-05-11.bin as well, but I've been keeping
> the former as a constant throughout the PCIe patch series testing once
> I realized how critical it was (old beta EEPROM versions found in some
> CM4s made everything much harder initially).

Sorry, i was a little bit unspecific. This the first level bootloader
stored in the EEPROM. I meant the VC firmware version from the SD card
which is logged in dmesg:

raspberrypi-firmware soc:firmware: Attached to firmware from ...

> In case the config matters:
>
>      [all]
>      BOOT_UART=0
>      WAKE_ON_GPIO=1
>      POWER_OFF_ON_HALT=0
>      BOOT_ORDER=0xf25641
>      ENABLE_SELF_UPDATE=1
>
>> - did you use arm64/defconfig or something special?
> I'm using a “distribution config”, starting from the latest arm64 config
> found in Debian unstable (6.5.10-1), and applying `make oldconfig`.
>
> You'll find it attached.
Thanks
>
>
> Cheers,
>
> _______________________________________________
> linux-arm-kernel mailing list
> linux-arm-kernel at lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/linux-arm-kernel