[RFC v5 5/5] dt-bindings: firmware: arm,scmi: Add support for pinctrl protocol

[Oleksii Moisieiev]

On 27.10.23 11:56, Krzysztof Kozlowski wrote:
> On 27/10/2023 08:28, Oleksii Moisieiev wrote:
>> Add new SCMI v3.2 pinctrl protocol bindings definitions and example.
>>
>> Signed-off-by: Oleksii Moisieiev <oleksii_moisieiev at epam.com>
>>
>> ---
>> Changes v3 -> v4
>>    - reworked protocol at 19 format
>> ---
>>   .../bindings/firmware/arm,scmi.yaml           | 53 +++++++++++++++++++
>>   1 file changed, 53 insertions(+)
>>
>> diff --git a/Documentation/devicetree/bindings/firmware/arm,scmi.yaml b/Documentation/devicetree/bindings/firmware/arm,scmi.yaml
>> index 5824c43e9893..5318fe72354e 100644
>> --- a/Documentation/devicetree/bindings/firmware/arm,scmi.yaml
>> +++ b/Documentation/devicetree/bindings/firmware/arm,scmi.yaml
>> @@ -233,6 +233,39 @@ properties:
>>         reg:
>>           const: 0x18
>>   
>> +  protocol at 19:
>> +    type: object
>> +    allOf:
>> +      - $ref: "#/$defs/protocol-node"
>> +      - $ref: "../pinctrl/pinctrl.yaml"
> 
> This is a friendly reminder during the review process.
> 
> It seems my previous comments were not fully addressed. Maybe my
> feedback got lost between the quotes, maybe you just forgot to apply it.
> Please go back to the previous discussion and either implement all
> requested changes or keep discussing them.
> 
> Thank you.


Hi Krzysztof,

I'm sorry for the inconvenience.
The intention behind sharing this RFC was to initiate the review process 
for the changes I've been making to the pinctrl driver, aligning it with 
the updates in the DEN0056E beta2 document.

I am still actively working on these changes, and I fully intend to 
address and resolve the binding issues and all previously mentioned 
comments in the final v5 patch series.

Best regards,
Oleksii.

> 
> It does not look like you tested the bindings, at least after quick
> look. Please run `make dt_binding_check` (see
> Documentation/devicetree/bindings/writing-schema.rst for instructions).
> Maybe you need to update your dtschema and yamllint.
> 
> 
> Best regards,
> Krzysztof
>