[PATCH v2 3/4] ARM: dts: qcom: msm8960: Add USB node

Krzysztof Kozlowski krzysztof.kozlowski at linaro.org
Tue May 30 06:22:36 PDT 2023


On 28/05/2023 02:10, Rudraksha Gupta wrote:
> Add the required nodes to support USB on the MSM8960 SoC. As it's very
> similar to the APQ8064 SoC, the nodes are almost identical
> 
> Add a label to sleep_clk for the USB node to reference
> 
> Signed-off-by: Rudraksha Gupta <guptarud at gmail.com>


> +		usb1: usb at 12500000 {
> +			compatible = "qcom,ci-hdrc";
> +			reg = <0x12500000 0x200>,
> +			      <0x12500200 0x200>;
> +			interrupts = <GIC_SPI 100 IRQ_TYPE_LEVEL_HIGH>;
> +			clocks = <&gcc USB_HS1_XCVR_CLK>, <&gcc USB_HS1_H_CLK>;
> +			clock-names = "core", "iface";
> +			assigned-clocks = <&gcc USB_HS1_XCVR_CLK>;
> +			assigned-clock-rates = <60000000>;
> +			resets = <&gcc USB_HS1_RESET>;
> +			reset-names = "core";
> +			phy_type = "ulpi";
> +			ahb-burst-config = <0>;
> +			phys = <&usb_hs1_phy>;
> +			phy-names = "usb-phy";
> +			status = "disabled";

status is the last

> +			#reset-cells = <1>;
> +
> +			ulpi {
> +				usb_hs1_phy: phy {
> +					compatible = "qcom,usb-hs-phy-msm8960",
> +						     "qcom,usb-hs-phy";
> +					clocks = <&sleep_clk>, <&cxo_board>;
> +					clock-names = "sleep", "ref";
> +					resets = <&usb1 0>;
> +					reset-names = "por";
> +					#phy-cells = <0>;
> +				};
> +			};
> +		};
> +

Don't add stray blank lines.

Best regards,
Krzysztof




More information about the linux-arm-kernel mailing list