[PATCH 11/23] arm64: zynqmp: Use assigned-clock-rates for setting up SD clock in SOM

[Michal Simek]

On 5/2/23 15:35, Michal Simek wrote:
> With limited low level configuration done via psu-init only IPs connected
> on SOM are initialized and configured. All IPs connected to carrier card
> are not initialized. There is a need to do proper reset, pin configuration
> and also clock setting.
> The patch targets the last part which is setting up proper clock for EMMC
> on production SOMs and SD on kv260-revB.
> 
> Signed-off-by: Michal Simek <michal.simek at amd.com>
> ---
> 
>   arch/arm64/boot/dts/xilinx/zynqmp-clk-ccf.dtsi       | 5 ++++-
>   arch/arm64/boot/dts/xilinx/zynqmp-sck-kv-g-revA.dtso | 1 +
>   arch/arm64/boot/dts/xilinx/zynqmp-sck-kv-g-revB.dtso | 1 +
>   arch/arm64/boot/dts/xilinx/zynqmp-sm-k26-revA.dts    | 1 +
>   4 files changed, 7 insertions(+), 1 deletion(-)
> 
> diff --git a/arch/arm64/boot/dts/xilinx/zynqmp-clk-ccf.dtsi b/arch/arm64/boot/dts/xilinx/zynqmp-clk-ccf.dtsi
> index 5e7e1bf5b811..681885c9bcbb 100644
> --- a/arch/arm64/boot/dts/xilinx/zynqmp-clk-ccf.dtsi
> +++ b/arch/arm64/boot/dts/xilinx/zynqmp-clk-ccf.dtsi
> @@ -2,7 +2,8 @@
>   /*
>    * Clock specification for Xilinx ZynqMP
>    *
> - * (C) Copyright 2017 - 2021, Xilinx, Inc.
> + * (C) Copyright 2017 - 2022, Xilinx, Inc.
> + * (C) Copyright 2022 - 2023, Advanced Micro Devices, Inc.
>    *
>    * Michal Simek <michal.simek at xilinx.com>
>    */
> @@ -185,10 +186,12 @@ &sata {
>   
>   &sdhci0 {
>   	clocks = <&zynqmp_clk SDIO0_REF>, <&zynqmp_clk LPD_LSBUS>;
> +	assigned-clocks = <&zynqmp_clk SDIO0_REF>;
>   };
>   
>   &sdhci1 {
>   	clocks = <&zynqmp_clk SDIO1_REF>, <&zynqmp_clk LPD_LSBUS>;
> +	assigned-clocks = <&zynqmp_clk SDIO1_REF>;
>   };
>   
>   &spi0 {
> diff --git a/arch/arm64/boot/dts/xilinx/zynqmp-sck-kv-g-revA.dtso b/arch/arm64/boot/dts/xilinx/zynqmp-sck-kv-g-revA.dtso
> index 2f7a17ec58b4..cb4a5126c4ec 100644
> --- a/arch/arm64/boot/dts/xilinx/zynqmp-sck-kv-g-revA.dtso
> +++ b/arch/arm64/boot/dts/xilinx/zynqmp-sck-kv-g-revA.dtso
> @@ -133,6 +133,7 @@ &sdhci1 { /* on CC with tuned parameters */
>   	no-1-8-v;
>   	disable-wp;
>   	xlnx,mio-bank = <1>;
> +	assigned-clock-rates = <187498123>;
>   };
>   
>   &gem3 { /* required by spec */
> diff --git a/arch/arm64/boot/dts/xilinx/zynqmp-sck-kv-g-revB.dtso b/arch/arm64/boot/dts/xilinx/zynqmp-sck-kv-g-revB.dtso
> index 4695e0e3714f..31bc120dee49 100644
> --- a/arch/arm64/boot/dts/xilinx/zynqmp-sck-kv-g-revB.dtso
> +++ b/arch/arm64/boot/dts/xilinx/zynqmp-sck-kv-g-revB.dtso
> @@ -116,6 +116,7 @@ &sdhci1 { /* on CC with tuned parameters */
>   	clk-phase-sd-hs = <126>, <60>;
>   	clk-phase-uhs-sdr25 = <120>, <60>;
>   	clk-phase-uhs-ddr50 = <126>, <48>;
> +	assigned-clock-rates = <187498123>;
>   };
>   
>   &gem3 { /* required by spec */
> diff --git a/arch/arm64/boot/dts/xilinx/zynqmp-sm-k26-revA.dts b/arch/arm64/boot/dts/xilinx/zynqmp-sm-k26-revA.dts
> index 340a5c43a8b6..d3c6a9feb114 100644
> --- a/arch/arm64/boot/dts/xilinx/zynqmp-sm-k26-revA.dts
> +++ b/arch/arm64/boot/dts/xilinx/zynqmp-sm-k26-revA.dts
> @@ -178,6 +178,7 @@ &sdhci0 { /* MIO13-23 - 16GB emmc MTFC16GAPALBH-IT - U133A */
>   	disable-wp;
>   	bus-width = <8>;
>   	xlnx,mio-bank = <0>;
> +	assigned-clock-rates = <187498123>;
>   };
>   
>   &spi1 { /* MIO6, 9-11 */

Applied.
M

-- 
Michal Simek, Ing. (M.Eng), OpenPGP -> KeyID: FE3D1F91
w: www.monstr.eu p: +42-0-721842854
Maintainer of Linux kernel - Xilinx Microblaze
Maintainer of Linux kernel - Xilinx Zynq ARM and ZynqMP/Versal ARM64 SoCs
U-Boot custodian - Xilinx Microblaze/Zynq/ZynqMP/Versal/Versal NET SoCs
TF-A maintainer - Xilinx ZynqMP/Versal/Versal NET SoCs