[PATCH v5 1/3] dt-bindings: misc: esm: Add ESM support for TI K3 devices

Krzysztof Kozlowski krzysztof.kozlowski at linaro.org
Wed May 3 23:51:45 PDT 2023


On 03/05/2023 14:32, Neha Malcom Francis wrote:
> Document the binding for TI K3 ESM (Error Signaling Module) block.
> 
> Signed-off-by: Neha Malcom Francis <n-francis at ti.com>

???

You were already asked to keep it and it was in v4, so you had to
explicitly remove it from your git... It takes me time to figure out
what is happening here. But ok, if you do not keep my review, comment
follows.

...

> +  ti,esm-pins:
> +    $ref: /schemas/types.yaml#/definitions/uint32-array
> +    description:
> +      integer array of ESM interrupt pins to route to external event pin
> +      which can be used to reset the SoC.
> +    minItems: 1
> +    maxItems: 255
> +
> +additionalProperties: false

Put aditionalProperties after required:, just like in example-schema.

> +
> +required:
> +  - compatible
> +  - reg
> +  - ti,esm-pins



Best regards,
Krzysztof




More information about the linux-arm-kernel mailing list