[PATCH v3 15/18] pinctrl: qcom: Use qcom_scm_io_update_field()

Mukesh Ojha quic_mojha at quicinc.com
Wed May 3 10:02:29 PDT 2023


Use qcom_scm_io_update_field() exported function introduced
in last commit.

Acked-by: Linus Walleij <linus.walleij at linaro.org>
Signed-off-by: Mukesh Ojha <quic_mojha at quicinc.com>
---
 drivers/pinctrl/qcom/pinctrl-msm.c | 11 ++++-------
 1 file changed, 4 insertions(+), 7 deletions(-)

diff --git a/drivers/pinctrl/qcom/pinctrl-msm.c b/drivers/pinctrl/qcom/pinctrl-msm.c
index 4515f37..856ebbf 100644
--- a/drivers/pinctrl/qcom/pinctrl-msm.c
+++ b/drivers/pinctrl/qcom/pinctrl-msm.c
@@ -1042,6 +1042,7 @@ static int msm_gpio_irq_set_type(struct irq_data *d, unsigned int type)
 	unsigned long flags;
 	bool was_enabled;
 	u32 val;
+	u32 mask;
 
 	if (msm_gpio_needs_dual_edge_parent_workaround(d, type)) {
 		set_bit(d->hwirq, pctrl->dual_edge_irqs);
@@ -1075,23 +1076,19 @@ static int msm_gpio_irq_set_type(struct irq_data *d, unsigned int type)
 	 * With intr_target_use_scm interrupts are routed to
 	 * application cpu using scm calls.
 	 */
+	mask = (7 << g->intr_target_bit);
 	if (pctrl->intr_target_use_scm) {
 		u32 addr = pctrl->phys_base[0] + g->intr_target_reg;
 		int ret;
 
-		qcom_scm_io_readl(addr, &val);
-
-		val &= ~(7 << g->intr_target_bit);
-		val |= g->intr_target_kpss_val << g->intr_target_bit;
-
-		ret = qcom_scm_io_writel(addr, val);
+		ret = qcom_scm_io_update_field(addr, mask, g->intr_target_kpss_val);
 		if (ret)
 			dev_err(pctrl->dev,
 				"Failed routing %lu interrupt to Apps proc",
 				d->hwirq);
 	} else {
 		val = msm_readl_intr_target(pctrl, g);
-		val &= ~(7 << g->intr_target_bit);
+		val &= ~mask;
 		val |= g->intr_target_kpss_val << g->intr_target_bit;
 		msm_writel_intr_target(val, pctrl, g);
 	}
-- 
2.7.4




More information about the linux-arm-kernel mailing list