[PATCH v2] thermal/drivers/sun8i: Fix some error handling paths in sun8i_ths_probe()

[Daniel Lezcano]

On 13/06/2023 11:16, Maxime Ripard wrote:
> On Tue, Jun 13, 2023 at 10:49:24AM +0200, Daniel Lezcano wrote:
>> On 15/05/2023 14:33, Ondřej Jirman wrote:
>>> Hi Maxime,
>>>
>>> On Mon, May 15, 2023 at 01:54:41PM +0200, Maxime Ripard wrote:
>>>> Hi,
>>>>
>>>> On Sun, May 14, 2023 at 08:46:05PM +0200, Christophe JAILLET wrote:
>>>>> Should an error occur after calling sun8i_ths_resource_init() in the probe
>>>>> function, some resources need to be released, as already done in the
>>>>> .remove() function.
>>>>>
>>>>> Switch to the devm_clk_get_enabled() helper and add a new devm_action to
>>>>> turn sun8i_ths_resource_init() into a fully managed function.
>>>>>
>>>>> Move the place where reset_control_deassert() is called so that the
>>>>> recommended order of reset release/clock enable steps is kept.
>>>>> A64 manual states that:
>>>>>
>>>>> 	3.3.6.4. Gating and reset
>>>>>
>>>>> 	Make sure that the reset signal has been released before the release of
>>>>> 	module clock gating;
>>>>>
>>>>> This fixes the issue and removes some LoC at the same time.
>>>>
>>>> It should really be three different patches:
>>>>    - One to fix the resource release, that can be backported to stable
>>>>      releases
>>>>    - One to switch to devm_clk_get_enabled
>>>>    - and one to change the order of clock enable vs reset deassertion
>>>
>>> The order was correct before this patch. I don't think an incorrect order
>>> should be intorduced, even if temporarily between two patches.
>>
>> Maxime ?
> 
> I agree with Ondřej

Thanks, I applied the patch


-- 
<http://www.linaro.org/> Linaro.org │ Open source software for ARM SoCs

Follow Linaro:  <http://www.facebook.com/pages/Linaro> Facebook |
<http://twitter.com/#!/linaroorg> Twitter |
<http://www.linaro.org/linaro-blog/> Blog