[PATCH] ARM: dts: ti: split interrupts per cells

[Krzysztof Kozlowski]

Each interrupt should be in its own cell.  This is much more readable.

Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski at linaro.org>
---
 arch/arm/boot/dts/ti/davinci/da850.dtsi           | 15 +++++----------
 arch/arm/boot/dts/ti/omap/am33xx-l4.dtsi          | 10 +++++-----
 arch/arm/boot/dts/ti/omap/am437x-l4.dtsi          | 12 ++++++------
 arch/arm/boot/dts/ti/omap/omap5-board-common.dtsi |  6 +++---
 4 files changed, 19 insertions(+), 24 deletions(-)

diff --git a/arch/arm/boot/dts/ti/davinci/da850.dtsi b/arch/arm/boot/dts/ti/davinci/da850.dtsi
index e46e4d22db39..afa6268a17d7 100644
--- a/arch/arm/boot/dts/ti/davinci/da850.dtsi
+++ b/arch/arm/boot/dts/ti/davinci/da850.dtsi
@@ -421,7 +421,7 @@ edma0: edma at 0 {
 			/* eDMA3 CC0: 0x01c0 0000 - 0x01c0 7fff */
 			reg = <0x0 0x8000>;
 			reg-names = "edma3_cc";
-			interrupts = <11 12>;
+			interrupts = <11>, <12>;
 			interrupt-names = "edma3_ccint", "edma3_ccerrint";
 			#dma-cells = <2>;
 
@@ -447,7 +447,7 @@ edma1: edma at 230000 {
 			/* eDMA3 CC1: 0x01e3 0000 - 0x01e3 7fff */
 			reg = <0x230000 0x8000>;
 			reg-names = "edma3_cc";
-			interrupts = <93 94>;
+			interrupts = <93>, <94>;
 			interrupt-names = "edma3_ccint", "edma3_ccerrint";
 			#dma-cells = <2>;
 
@@ -494,8 +494,7 @@ serial2: serial at 10d000 {
 		rtc0: rtc at 23000 {
 			compatible = "ti,da830-rtc";
 			reg = <0x23000 0x1000>;
-			interrupts = <19
-				      19>;
+			interrupts = <19>, <19>;
 			clocks = <&pll0_auxclk>;
 			clock-names = "int-clk";
 			status = "disabled";
@@ -725,11 +724,7 @@ eth0: ethernet at 220000 {
 			ti,davinci-ctrl-ram-offset = <0>;
 			ti,davinci-ctrl-ram-size = <0x2000>;
 			local-mac-address = [ 00 00 00 00 00 00 ];
-			interrupts = <33
-					34
-					35
-					36
-					>;
+			interrupts = <33>, <34>, <35>,<36>;
 			clocks = <&psc1 5>;
 			power-domains = <&psc1 5>;
 			status = "disabled";
@@ -748,7 +743,7 @@ gpio: gpio at 226000 {
 			gpio-controller;
 			#gpio-cells = <2>;
 			reg = <0x226000 0x1000>;
-			interrupts = <42 43 44 45 46 47 48 49 50>;
+			interrupts = <42>, <43>, <44>, <45>, <46>, <47>, <48>, <49>, <50>;
 			ti,ngpio = <144>;
 			ti,davinci-gpio-unbanked = <0>;
 			clocks = <&psc1 3>;
diff --git a/arch/arm/boot/dts/ti/omap/am33xx-l4.dtsi b/arch/arm/boot/dts/ti/omap/am33xx-l4.dtsi
index 7e50fe633d8a..d6a143abae5f 100644
--- a/arch/arm/boot/dts/ti/omap/am33xx-l4.dtsi
+++ b/arch/arm/boot/dts/ti/omap/am33xx-l4.dtsi
@@ -455,8 +455,8 @@ target-module at 3e000 {			/* 0x44e3e000, ap 35 60.0 */
 			rtc: rtc at 0 {
 				compatible = "ti,am3352-rtc", "ti,da830-rtc";
 				reg = <0x0 0x1000>;
-				interrupts = <75
-					      76>;
+				interrupts = <75>,
+					     <76>;
 			};
 		};
 
@@ -739,7 +739,7 @@ mac: ethernet at 0 {
 				 * c0_tx_pend
 				 * c0_misc_pend
 				 */
-				interrupts = <40 41 42 43>;
+				interrupts = <40>, <41>, <42>, <43>;
 				ranges = <0 0 0x8000>;
 				syscon = <&scm_conf>;
 				status = "disabled";
@@ -779,7 +779,7 @@ mac_sw: switch at 0 {
 				syscon = <&scm_conf>;
 				status = "disabled";
 
-				interrupts = <40 41 42 43>;
+				interrupts = <40>, <41>, <42>, <43>;
 				interrupt-names = "rx_thresh", "rx", "tx", "misc";
 
 				ethernet-ports {
@@ -899,7 +899,7 @@ pruss_mii_rt: mii-rt at 32000 {
 				pruss_intc: interrupt-controller at 20000 {
 					compatible = "ti,pruss-intc";
 					reg = <0x20000 0x2000>;
-					interrupts = <20 21 22 23 24 25 26 27>;
+					interrupts = <20>, <21>, <22>, <23>, <24>, <25>, <26>, <27>;
 					interrupt-names = "host_intr0", "host_intr1",
 							  "host_intr2", "host_intr3",
 							  "host_intr4", "host_intr5",
diff --git a/arch/arm/boot/dts/ti/omap/am437x-l4.dtsi b/arch/arm/boot/dts/ti/omap/am437x-l4.dtsi
index 415210b034ef..824b9415ebbe 100644
--- a/arch/arm/boot/dts/ti/omap/am437x-l4.dtsi
+++ b/arch/arm/boot/dts/ti/omap/am437x-l4.dtsi
@@ -442,8 +442,8 @@ rtc: rtc at 0 {
 				compatible = "ti,am4372-rtc", "ti,am3352-rtc",
 					     "ti,da830-rtc";
 				reg = <0x0 0x1000>;
-				interrupts = <GIC_SPI 75 IRQ_TYPE_LEVEL_HIGH
-					      GIC_SPI 76 IRQ_TYPE_LEVEL_HIGH>;
+				interrupts = <GIC_SPI 75 IRQ_TYPE_LEVEL_HIGH>,
+					     <GIC_SPI 76 IRQ_TYPE_LEVEL_HIGH>;
 				clocks = <&clk_32768_ck>;
 				clock-names = "int-clk";
 				system-power-controller;
@@ -549,10 +549,10 @@ mac_sw: switch at 0 {
 				syscon = <&scm_conf>;
 				status = "disabled";
 
-				interrupts = <GIC_SPI 40 IRQ_TYPE_LEVEL_HIGH
-					      GIC_SPI 41 IRQ_TYPE_LEVEL_HIGH
-					      GIC_SPI 42 IRQ_TYPE_LEVEL_HIGH
-					      GIC_SPI 43 IRQ_TYPE_LEVEL_HIGH>;
+				interrupts = <GIC_SPI 40 IRQ_TYPE_LEVEL_HIGH>,
+					     <GIC_SPI 41 IRQ_TYPE_LEVEL_HIGH>,
+					     <GIC_SPI 42 IRQ_TYPE_LEVEL_HIGH>,
+					     <GIC_SPI 43 IRQ_TYPE_LEVEL_HIGH>;
 				interrupt-names = "rx_thresh", "rx", "tx", "misc";
 
 				ethernet-ports {
diff --git a/arch/arm/boot/dts/ti/omap/omap5-board-common.dtsi b/arch/arm/boot/dts/ti/omap/omap5-board-common.dtsi
index 6f46f1ecf1e5..8946b5580cd9 100644
--- a/arch/arm/boot/dts/ti/omap/omap5-board-common.dtsi
+++ b/arch/arm/boot/dts/ti/omap/omap5-board-common.dtsi
@@ -415,9 +415,9 @@ rtc {
 
 		gpadc: gpadc {
 			compatible = "ti,palmas-gpadc";
-			interrupts = <18 0
-				      16 0
-				      17 0>;
+			interrupts = <18 0>,
+				     <16 0>,
+				     <17 0>;
 			#io-channel-cells = <1>;
 			ti,channel0-current-microamp = <5>;
 			ti,channel3-current-microamp = <10>;
-- 
2.34.1