[PATCH v2 1/3] ARM: dts: imx6: phytec: fix RTC interrupt level

Andrej Picej andrej.picej at norik.com
Wed Jul 19 04:43:26 PDT 2023


RTC interrupt level should be set to "LOW". This was revealed by the
introduction of commit:

  f181987ef477 ("rtc: m41t80: use IRQ flags obtained from fwnode")

which changed the way IRQ type is obtained.

Signed-off-by: Andrej Picej <andrej.picej at norik.com>
---
Changes in v2:
 - no changes
---
 arch/arm/boot/dts/nxp/imx/imx6qdl-phytec-mira.dtsi | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/arch/arm/boot/dts/nxp/imx/imx6qdl-phytec-mira.dtsi b/arch/arm/boot/dts/nxp/imx/imx6qdl-phytec-mira.dtsi
index 1a599c294ab8..1ca4d219609f 100644
--- a/arch/arm/boot/dts/nxp/imx/imx6qdl-phytec-mira.dtsi
+++ b/arch/arm/boot/dts/nxp/imx/imx6qdl-phytec-mira.dtsi
@@ -182,7 +182,7 @@ i2c_rtc: rtc at 68 {
 		pinctrl-0 = <&pinctrl_rtc_int>;
 		reg = <0x68>;
 		interrupt-parent = <&gpio7>;
-		interrupts = <8 IRQ_TYPE_LEVEL_HIGH>;
+		interrupts = <8 IRQ_TYPE_LEVEL_LOW>;
 		status = "disabled";
 	};
 };
-- 
2.25.1




More information about the linux-arm-kernel mailing list