[PATCH net-next 2/2] net: stmmac: platform: add support for phy-supply

[Marco Felsch]

On 23-07-18, Andrew Lunn wrote:
> > +static int stmmac_phy_power(struct platform_device *pdev,
> > +			    struct plat_stmmacenet_data *plat,
> > +			    bool enable)
> > +{
> > +	struct regulator *regulator = plat->phy_regulator;
> > +	int ret = 0;
> > +
> > +	if (regulator) {
> > +		if (enable)
> > +			ret = regulator_enable(regulator);
> > +		else
> > +			regulator_disable(regulator);
> > +	}
> > +
> > +	if (ret)
> > +		dev_err(&pdev->dev, "Fail to enable regulator\n");
> 
> 'enable' is only correct 50% of the time.

You mean to move it under the enable path.

> > @@ -742,6 +786,8 @@ static int __maybe_unused stmmac_pltfr_suspend(struct device *dev)
> >  	if (priv->plat->exit)
> >  		priv->plat->exit(pdev, priv->plat->bsp_priv);
> >  
> > +	stmmac_phy_power_off(pdev, priv->plat);
> > +
> 
> What about WOL? You probably want to leave the PHY with power in that
> case.

Good point didn't consider WOL. Is there a way to check if WOL is
enabled?

Regards,
  Marco

> 
> > @@ -757,6 +803,11 @@ static int __maybe_unused stmmac_pltfr_resume(struct device *dev)
> >  	struct net_device *ndev = dev_get_drvdata(dev);
> >  	struct stmmac_priv *priv = netdev_priv(ndev);
> >  	struct platform_device *pdev = to_platform_device(dev);
> > +	int ret;
> > +
> > +	ret = stmmac_phy_power_on(pdev, priv->plat);
> > +	if (ret)
> > +		return ret;
> 
> And this needs to balance with _suspend when WOL is being used.
> 
>     Andrew
>