[PATCH v1] spi: Use dev_err_probe instead of dev_err

[王明-软件底层技术部]

It is possible that dma_request_chan will return EPROBE_DEFER,
which means that dev is not ready yet. In this case,
dev_err(dev), there will be no output. This patch fixes the bug.

Signed-off-by: Wang Ming <machel at vivo.com>
---
 drivers/spi/spi-bcm2835.c | 8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/drivers/spi/spi-bcm2835.c b/drivers/spi/spi-bcm2835.c
index 3b253da98c05..cbf025054c96 100644
--- a/drivers/spi/spi-bcm2835.c
+++ b/drivers/spi/spi-bcm2835.c
@@ -903,15 +903,15 @@ static int bcm2835_dma_init(struct spi_controller *ctlr, struct device *dev,
 	/* get tx/rx dma */
 	ctlr->dma_tx = dma_request_chan(dev, "tx");
 	if (IS_ERR(ctlr->dma_tx)) {
-		dev_err(dev, "no tx-dma configuration found - not using dma mode\n");
-		ret = PTR_ERR(ctlr->dma_tx);
+		ret = dev_err_probe(dev, PTR_ERR(ctlr->dma_tx),
+							"no tx-dma configuration found - not using dma mode\n");
 		ctlr->dma_tx = NULL;
 		goto err;
 	}
 	ctlr->dma_rx = dma_request_chan(dev, "rx");
 	if (IS_ERR(ctlr->dma_rx)) {
-		dev_err(dev, "no rx-dma configuration found - not using dma mode\n");
-		ret = PTR_ERR(ctlr->dma_rx);
+		ret = dev_err_probe(dev, PTR_ERR(ctlr->dma_rx),
+							"no rx-dma configuration found - not using dma mode\n");
 		ctlr->dma_rx = NULL;
 		goto err_release;
 	}
-- 
2.25.1