[PATCH] Documentation/process: maintainer-soc: document dtbs_check requirement for Samsung

[Krzysztof Kozlowski]

Samsung ARM/ARM64 SoCs (except legacy S5PV210) are also expected not to
bring any new dtbs_check warnings.  In fact this have been already
enforced and tested since few release.

Cc: Conor Dooley <conor.dooley at microchip.com>
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski at linaro.org>

---

Not sure where to document this. Creating new maintainer profile for
Samsung SoC would be an overkill. OTOH, more SoCs might want to grow
this list, so this also scales poor.
---
 Documentation/process/maintainer-soc.rst | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/Documentation/process/maintainer-soc.rst b/Documentation/process/maintainer-soc.rst
index 49f08289d62c..12637530d68f 100644
--- a/Documentation/process/maintainer-soc.rst
+++ b/Documentation/process/maintainer-soc.rst
@@ -133,8 +133,8 @@ with the dt-bindings that describe the ABI.  Please read the section
 more information on the validation of devicetrees.
 
 For new platforms, or additions to existing ones, ``make dtbs_check`` should not
-add any new warnings.  For RISC-V, as it has the advantage of being a newer
-architecture, ``make dtbs_check W=1`` is required to not add any new warnings.
+add any new warnings.  For RISC-V and Samsung SoC, ``make dtbs_check W=1`` is
+required to not add any new warnings.
 If in any doubt about a devicetree change, reach out to the devicetree
 maintainers.
 
-- 
2.34.1