[PATCH v3 4/6] arm64: dts: qcom: ipq5332: Add USB related nodes
Krzysztof Kozlowski
krzysztof.kozlowski at linaro.org
Tue Jul 11 02:01:03 PDT 2023
On 11/07/2023 10:51, Varadarajan Narayanan wrote:
> Add USB phy and controller nodes.
>
> Signed-off-by: Varadarajan Narayanan <quic_varada at quicinc.com>
> ---
> v1:
> Rename phy node
I don't see any improvements.
> Change compatible from m31,ipq5332-usb-hsphy -> qcom,ipq5332-usb-hsphy
> Remove 'qscratch' from phy node
> Fix alignment and upper-case hex no.s
> Add clock definition for the phy
> Remove snps,ref-clock-period-ns as it is not used. dwc3_ref_clk_period()
> in dwc3/core.c takes the frequency from ref clock and calculates fladj
> as appropriate.
> ---
> arch/arm64/boot/dts/qcom/ipq5332.dtsi | 54 +++++++++++++++++++++++++++++++++++
> 1 file changed, 54 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/qcom/ipq5332.dtsi b/arch/arm64/boot/dts/qcom/ipq5332.dtsi
> index 8bfc2db..c945ff6 100644
> --- a/arch/arm64/boot/dts/qcom/ipq5332.dtsi
> +++ b/arch/arm64/boot/dts/qcom/ipq5332.dtsi
> @@ -405,6 +405,60 @@
> status = "disabled";
> };
> };
> +
> + usbphy0: ipq5332-hsphy at 7b000 {
Node names should be generic. See also an explanation and list of
examples (not exhaustive) in DT specification:
https://devicetree-specification.readthedocs.io/en/latest/chapter2-devicetree-basics.html#generic-names-recommendation
"phy"
> + compatible = "qcom,ipq5332-usb-hsphy";
> + reg = <0x0007b000 0x12c>;
> +
> + clocks = <&gcc GCC_USB0_PHY_CFG_AHB_CLK>;
> + clock-names = "cfg_ahb";
> +
> + resets = <&gcc GCC_QUSB2_0_PHY_BCR>;
> +
> + status = "disabled";
> + };
> +
> + usb2: usb2 at 8a00000 {
It does not look like you tested the DTS against bindings. Please run
`make dtbs_check` (see
Documentation/devicetree/bindings/writing-schema.rst or
https://www.linaro.org/blog/tips-and-tricks-for-validating-devicetree-sources-with-the-devicetree-schema/
for instructions).
> + compatible = "qcom,ipq5332-dwc3", "qcom,dwc3";
> +
No need for blank line.
> + reg = <0x08af8800 0x400>;
> +
> + interrupts = <GIC_SPI 62 IRQ_
Best regards,
Krzysztof
More information about the linux-arm-kernel
mailing list