[PATCH 2/2] ARM: dts: imx6: pfla02: Fix SD card reboot problem
Andrej Picej
andrej.picej at norik.com
Wed Jul 5 01:28:22 PDT 2023
Hi Marco,
On 4. 07. 23 10:17, Marco Felsch wrote:
> On 23-07-04, Andrej Picej wrote:
>> If regulator is not marked as always-on the regulator gets disabled on
>> reboot breaking the next boot.
>>
>> Signed-off-by: Andrej Picej <andrej.picej at norik.com>
>> ---
>> arch/arm/boot/dts/imx6qdl-phytec-pfla02.dtsi | 1 +
>> 1 file changed, 1 insertion(+)
>>
>> diff --git a/arch/arm/boot/dts/imx6qdl-phytec-pfla02.dtsi b/arch/arm/boot/dts/imx6qdl-phytec-pfla02.dtsi
>> index 80adb2a02cc9..25d6a036d5b8 100644
>> --- a/arch/arm/boot/dts/imx6qdl-phytec-pfla02.dtsi
>> +++ b/arch/arm/boot/dts/imx6qdl-phytec-pfla02.dtsi
>> @@ -192,6 +192,7 @@ vdd_3v3_pmic_io_reg: ldo6 {
>> vdd_sd0_reg: ldo9 {
>> regulator-min-microvolt = <3300000>;
>> regulator-max-microvolt = <3300000>;
>> + regulator-always-on;
>
> I think this is the supply for the sd-card, so you can make use of
> 'vmmc-supply'.
This is already the case:
> &usdhc3 {
> pinctrl-names = "default";
> pinctrl-0 = <&pinctrl_usdhc3
> &pinctrl_usdhc3_cdwp>;
> cd-gpios = <&gpio1 27 GPIO_ACTIVE_LOW>;
> wp-gpios = <&gpio1 29 GPIO_ACTIVE_HIGH>;
> vmmc-supply = <&vdd_sd0_reg>;
> status = "disabled";
> };
I think the main reason for a failed boot is that the PMIC doesn't get
reset and that the bootloader doesn't specifically enable the SD card
regulator.
Could this patch still be applied or should we put the fix in reset
routine/bootloader?
Best regards,
Andrej
>
> Regards,
> Marco
>
>> };
>>
>> vdd_sd1_reg: ldo10 {
>> --
>> 2.25.1
>>
>>
>>
More information about the linux-arm-kernel
mailing list