[RFT PATCH 2/3] arm64: dts: rockchip: correct audio-codec interrupt flag in Rock Pi 4B

[Krzysztof Kozlowski]

GPIO_ACTIVE_x flags are not correct in the context of interrupt flags.
These are simple defines so they could be used in DTS but they will not
have the same meaning: GPIO_ACTIVE_HIGH = 0 = IRQ_TYPE_NONE.

Correct the interrupt flags, assuming the author of the code wanted same
logical behavior behind the name "ACTIVE_xxx", this is:
  ACTIVE_LOW  => IRQ_TYPE_LEVEL_LOW

Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski at linaro.org>
---
 arch/arm64/boot/dts/rockchip/rk3399-rock-pi-4b-plus.dts | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/arch/arm64/boot/dts/rockchip/rk3399-rock-pi-4b-plus.dts b/arch/arm64/boot/dts/rockchip/rk3399-rock-pi-4b-plus.dts
index cec3b7b1b947..8a17c1eaae15 100644
--- a/arch/arm64/boot/dts/rockchip/rk3399-rock-pi-4b-plus.dts
+++ b/arch/arm64/boot/dts/rockchip/rk3399-rock-pi-4b-plus.dts
@@ -31,7 +31,7 @@ brcmf: wifi at 1 {
 		compatible = "brcm,bcm4329-fmac";
 		reg = <1>;
 		interrupt-parent = <&gpio0>;
-		interrupts = <RK_PA3 GPIO_ACTIVE_HIGH>;
+		interrupts = <RK_PA3 IRQ_TYPE_LEVEL_HIGH>;
 		interrupt-names = "host-wake";
 		pinctrl-names = "default";
 		pinctrl-0 = <&wifi_host_wake_l>;
-- 
2.34.1