[PATCH v3 5/5] meson saradc: support reading from channel 7 mux inputs

[Jonathan Cameron]

On Wed, 28 Jun 2023 01:37:18 +0300
George Stark <gnstark at sberdevices.ru> wrote:

> Add iio channel for every channel 7 mux input.
> Meson saradc channel 7 is connected to a mux that can switch channel
> input to well-known sources like Vdd, GND and several Vdd dividers.
> 
> Signed-off-by: George Stark <GNStark at sberdevices.ru>
> ---
>  drivers/iio/adc/meson_saradc.c | 83 ++++++++++++++++++++++++++++++++--
>  1 file changed, 79 insertions(+), 4 deletions(-)
> 
> diff --git a/drivers/iio/adc/meson_saradc.c b/drivers/iio/adc/meson_saradc.c
> index 4a9dacedb6c3..c99a55944ece 100644
> --- a/drivers/iio/adc/meson_saradc.c
> +++ b/drivers/iio/adc/meson_saradc.c
> @@ -163,6 +163,7 @@
>  #define MESON_SAR_ADC_MAX_FIFO_SIZE				32
>  #define MESON_SAR_ADC_TIMEOUT					100 /* ms */
>  #define MESON_SAR_ADC_VOLTAGE_AND_TEMP_CHANNEL			6
> +#define MESON_SAR_ADC_VOLTAGE_AND_MUX_CHANNEL			7
>  #define MESON_SAR_ADC_TEMP_OFFSET				27
>  
>  /* temperature sensor calibration information in eFuse */
> @@ -202,6 +203,19 @@
>  	.datasheet_name = "TEMP_SENSOR",				\
>  }
>  
> +#define MESON_SAR_ADC_MUX(_chan, _sel) {				\
> +	.type = IIO_VOLTAGE,						\
> +	.channel = _chan,						\
> +	.indexed = 1,							\
> +	.address = MESON_SAR_ADC_VOLTAGE_AND_MUX_CHANNEL,		\
> +	.info_mask_separate = BIT(IIO_CHAN_INFO_RAW) |			\
> +				BIT(IIO_CHAN_INFO_AVERAGE_RAW),		\
> +	.info_mask_shared_by_type = BIT(IIO_CHAN_INFO_SCALE),		\
> +	.info_mask_shared_by_all = BIT(IIO_CHAN_INFO_CALIBBIAS) |	\
> +				BIT(IIO_CHAN_INFO_CALIBSCALE),		\
> +	.datasheet_name = "SAR_ADC_MUX_"#_sel,				\
> +}
> +
>  enum meson_sar_adc_avg_mode {
>  	NO_AVERAGING = 0x0,
>  	MEAN_AVERAGING = 0x1,
> @@ -235,6 +249,27 @@ enum meson_sar_adc_channel_index {
>  	NUM_CHAN_7,
>  	NUM_CHAN_TEMP,
>  	NUM_CHAN_SOFT_TIMESTAMP,

Silly question... Why does this device have timestamp channels?
It has no buffer support so they don't 'do anything'.
If it had then putting other channels after that might have broken
things if not done very carefully (hence I went looking)

> +	NUM_MUX_0_VSS,
> +	NUM_MUX_1_VDD_DIV4,
> +	NUM_MUX_2_VDD_DIV2,
> +	NUM_MUX_3_VDD_MUL3_DIV4,
> +	NUM_MUX_4_VDD,
> +};
...

>  static const struct iio_chan_spec meson_sar_adc_iio_channels[] = {
> @@ -247,6 +282,11 @@ static const struct iio_chan_spec meson_sar_adc_iio_channels[] = {
>  	MESON_SAR_ADC_CHAN(NUM_CHAN_6),
>  	MESON_SAR_ADC_CHAN(NUM_CHAN_7),
>  	IIO_CHAN_SOFT_TIMESTAMP(NUM_CHAN_SOFT_TIMESTAMP),
> +	MESON_SAR_ADC_MUX(NUM_MUX_0_VSS, 0),
> +	MESON_SAR_ADC_MUX(NUM_MUX_1_VDD_DIV4, 1),
> +	MESON_SAR_ADC_MUX(NUM_MUX_2_VDD_DIV2, 2),
> +	MESON_SAR_ADC_MUX(NUM_MUX_3_VDD_MUL3_DIV4, 3),
> +	MESON_SAR_ADC_MUX(NUM_MUX_4_VDD, 4),
>  };

Jonathan