[PATCH 0/2] *** Add fixed-paritions to phyCORE-AM62x and phyCORE-AM64x ***

[Andrew Davis]

On 12/18/23 12:47 PM, Nathan Morrisson wrote:
> Hi Andrew,
> 
> We are adding the nodes directly to the device tree to match what is done in other device trees, for example: k3-am642-tqma64xxl.dtsi. You are correct that this could be done by the bootloader instead though. Why do you prefer having the bootloader add the nodes?
> 

k3-am642-tqma64xxl.dtsi should be fixed, it slipped past me and
shouldn't be used as a reference.

The bootloader might not fill it out at all, what if we start
using the new MTD GPT partitions? Then the new bootloaders
will have to start *removing* these stale half-nodes.

If the bootloader is going to add fixed partitions it should do
the whole job. There is no good reason to have a half complete
nodes here.

Andrew

> Regards,
> 
> Nathan
> 
> On 12/15/23 11:20 AM, Andrew Davis wrote:
>> On 12/15/23 1:18 PM, Nathan Morrisson wrote:
>>> Add a fixed-partitions node to the NOR flash of the phyCORE-AM62x
>>> and phyCORE-AM64x to enable the bootloader to fixup the partitions
>>> during boot.
>>>
>>
>> Why can't your bootloader add these nodes?
>>
>> Andrew
>>
>>> Nathan Morrisson (2):
>>>    arm64: dts: ti: k3-am62-phycore-som: Add fixed-partitions to NOR Flash
>>>    arm64: dts: ti: k3-am64-phycore-som: Add fixed-partitions to NOR Flash
>>>
>>>   arch/arm64/boot/dts/ti/k3-am62-phycore-som.dtsi | 6 ++++++
>>>   arch/arm64/boot/dts/ti/k3-am64-phycore-som.dtsi | 6 ++++++
>>>   2 files changed, 12 insertions(+)
>>>