[PATCH v2 1/1] arm64: dts: ti: k3-am62-wakeup: Configure ti-sysc for wkup_uart0

[Tony Lindgren]

* Nishanth Menon <nm at ti.com> [231215 16:00]:
> On 09:32-20231114, Tony Lindgren wrote:
> > -	wkup_uart0: serial at 2b300000 {
> > -		compatible = "ti,am64-uart", "ti,am654-uart";
> > -		reg = <0x00 0x2b300000 0x00 0x100>;
> > -		interrupts = <GIC_SPI 186 IRQ_TYPE_LEVEL_HIGH>;
> > +	target-module at 2b300000 {
> 
> should be  target-module at 2b300050 to match up with reg?

It's best to use the target-module IO range here, not the first reg.
The first reg may be tossed anywhere in the target module address
space depending on the device.

Ideally of course there would be just a standardized range of target
module related registers at the end of the IO space..

> > +		wkup_uart0: serial at 2b300000 {
> 
> serial at 0  to match up with reg?

Yes thanks for catching this. The 8250 IP is at the beginning of the
target module IO space. Will post an updated patch.

Regards,

Tony