[PATCH 2/4] dt-bindings: imx6q-pcie: Add host-wake-gpio property
Rob Herring
robh at kernel.org
Fri Dec 8 12:55:45 PST 2023
On Fri, Dec 08, 2023 at 11:00:19AM +0100, Lucas Stach wrote:
> Hi Sherry,
>
> Am Freitag, dem 08.12.2023 um 17:13 +0800 schrieb Sherry Sun:
> > Add host-wake-gpio property that can be used to wakeup the host
> > processor.
> >
> > Signed-off-by: Sherry Sun <sherry.sun at nxp.com>
> > Reviewed-by: Richard Zhu <hongxing.zhu at nxp.com>
> > ---
> > Documentation/devicetree/bindings/pci/fsl,imx6q-pcie.yaml | 4 ++++
> > 1 file changed, 4 insertions(+)
> >
> > diff --git a/Documentation/devicetree/bindings/pci/fsl,imx6q-pcie.yaml b/Documentation/devicetree/bindings/pci/fsl,imx6q-pcie.yaml
> > index 81bbb8728f0f..944f0f961809 100644
> > --- a/Documentation/devicetree/bindings/pci/fsl,imx6q-pcie.yaml
> > +++ b/Documentation/devicetree/bindings/pci/fsl,imx6q-pcie.yaml
> > @@ -72,6 +72,10 @@ properties:
> > L=operation state) (optional required).
> > type: boolean
> >
> > + host-wake-gpio:
>
> There is only one wake signal in PCIe and it has a defined direction,
> so there is no point in specifying that it is a host wakeup. Also GPIO
> handles without a traling 's' are deprecated. So this should be
>
> wake-gpios
Any standard PCI slot signals need to be documented in common PCI
schema. And they should start going into root port nodes rather than the
host bridge node because it's the root ports that correspond to slots
rather than the host bridge. We've just taken shortcuts because many
host bridges only have 1 root port.
Note that I'm in the middle of splitting pci-bus.yaml into host bridge,
PCI-PCI bridge (and RP), and common device schemas.
Rob
More information about the linux-arm-kernel
mailing list