[PATCH 3/3] arm64: dts: imx8mp-tqma8mpql-mba8mpxl: Fix USB connector description

[Fabio Estevam]

From: Fabio Estevam <festevam at denx.de>

The USB connector should not be placed under the dwc3 node.

Move the USB connector out of the SoC level and use port to describe
the connection to the dwc3 controller.

This fixes the following dt-schema warning:

imx8mp-tqma8mpql-mba8mpxl.dtb: usb at 38100000: Unevaluated properties are not allowed ('connector' was unexpected)
	from schema $id: http://devicetree.org/schemas/usb/snps,dwc3.yaml#
	
Signed-off-by: Fabio Estevam <festevam at denx.de>
---
 .../freescale/imx8mp-tqma8mpql-mba8mpxl.dts   | 26 ++++++++++++++-----
 1 file changed, 19 insertions(+), 7 deletions(-)

diff --git a/arch/arm64/boot/dts/freescale/imx8mp-tqma8mpql-mba8mpxl.dts b/arch/arm64/boot/dts/freescale/imx8mp-tqma8mpql-mba8mpxl.dts
index 4b161564a284..505b70cb2bd7 100644
--- a/arch/arm64/boot/dts/freescale/imx8mp-tqma8mpql-mba8mpxl.dts
+++ b/arch/arm64/boot/dts/freescale/imx8mp-tqma8mpql-mba8mpxl.dts
@@ -55,6 +55,21 @@ clk_xtal25: clk-xtal25 {
 		clock-frequency = <25000000>;
 	};
 
+	connector {
+		compatible = "gpio-usb-b-connector", "usb-b-connector";
+		type = "micro";
+		label = "X29";
+		pinctrl-names = "default";
+		pinctrl-0 = <&pinctrl_usbcon0>;
+		id-gpios = <&gpio1 10 GPIO_ACTIVE_HIGH>;
+
+		port {
+			usb_dr_connector: endpoint {
+				remote-endpoint = <&usb3_dwc>;
+			};
+		};
+	};
+
 	fan0: pwm-fan {
 		compatible = "pwm-fan";
 		pinctrl-names = "default";
@@ -625,13 +640,10 @@ &usb_dwc3_0 {
 	role-switch-default-mode = "peripheral";
 	status = "okay";
 
-	connector {
-		compatible = "gpio-usb-b-connector", "usb-b-connector";
-		type = "micro";
-		label = "X29";
-		pinctrl-names = "default";
-		pinctrl-0 = <&pinctrl_usbcon0>;
-		id-gpios = <&gpio1 10 GPIO_ACTIVE_HIGH>;
+	port {
+		usb3_dwc: endpoint {
+			remote-endpoint = <&usb_dr_connector>;
+		};
 	};
 };
 
-- 
2.34.1