[RFC PATCH v1 1/2] dt-bindings: pwm: rockchip: add interrupts property

Rob Herring robh at kernel.org
Fri Sep 30 12:55:24 PDT 2022


On Thu, 29 Sep 2022 16:04:00 +0200, Johan Jonker wrote:
> The Rockchip SoCs have 4 or more built-in PWM channels.
> 
> Configurable to operate in capture mode.
> Measures the high/low polarity effective cycles of this input waveform
> Generates a single interrupt at the transition of input waveform polarity
> 
> Configurable to operate in continuous mode or one-shot mode.
> One-shot operation will produce N + 1 periods of the waveform,
> where N is the repeat counter value, and generates a single interrupt at
> the end of operation.
> Continuous mode generates the waveform continuously and
> do not generates any interrupts.
> 
> Older SoCs have an interrupt for each node.
> Newer models share an interrupt.
> 
> Add interrupts property to the pwm-rockchip.yaml file.
> DT describes hardware. Rockchip PWM driver support for
> interrupts might not available.
> 
> Signed-off-by: Johan Jonker <jbx6244 at gmail.com>
> ---
>  Documentation/devicetree/bindings/pwm/pwm-rockchip.yaml | 3 +++
>  1 file changed, 3 insertions(+)
> 

Acked-by: Rob Herring <robh at kernel.org>



More information about the linux-arm-kernel mailing list