[PATCH 1/2] usb: mtu3: fix ep0's stall of out data stage

[Chunfeng Yun]

On Wed, 2022-09-28 at 11:30 -0400, Alan Stern wrote:
> On Wed, Sep 28, 2022 at 05:17:20PM +0800, Chunfeng Yun wrote:
> > It happens when enable uvc function, the flow as below:
> > the controller switch to data stage, then call
> >     -> foward_to_driver() -> composite_setup() ->
> > uvc_function_setup(),
> > it send out an event to user layer to notify it call
> >     -> ioctl() -> uvc_send_response() -> usb_ep_queue(),
> > but before the user call ioctl to queue ep0's buffer, the host
> > already send
> > out data, but the controller find that no buffer is queued to
> > receive data,
> > it send out STALL handshake.
> > 
> > To fix the issue, don't send out ACK of setup stage to switch to
> > out data
> > stage until the buffer is available.
> 
> You might find it is better to use the delayed_status routines
> already 
> present in the Gadget core.  Instead of delaying the response to the 
> Setup packet of the second control transfer, delay the status
> response 
> to the first control transfer.
Ok, I'll try to use delayed_status to handle this issue.

Thanks a lot.

> 
> This approach has the advantage of working even when the second
> transfer 
> is not control but something else, such as bulk.
> 
> Also it agrees better with the way the USB spec intends control 
> transfers to work.  The UDC is not supposed to complete the status
> stage 
> of a control transfer until the gadget has fully processed the 
> transfer's information and is ready to go forward.
> 
> Alan Stern