[PATCH V6 1/7] dt-bindings: remoteproc: imx_rproc: support i.MX8QXP

[Peng Fan (OSS)]

From: Peng Fan <peng.fan at nxp.com>

Add i.MX8QXP compatible

Add a new property fsl,resource-id for SoC which supports SCFW.
This property is used to check whether remote process is under control
of Linux or not.

Add fsl,entry-address to specify the entry address which used by SCFW
to kick M4.

To i.MX8QM/QXP, when M4 is in the same hardware partition with Cortex-A
cores, need power up M4 through SCFW, then M4 could start. So introduce
power-domains property

Reviewed-by: Rob Herring <robh at kernel.org>
Signed-off-by: Peng Fan <peng.fan at nxp.com>
---
 .../bindings/remoteproc/fsl,imx-rproc.yaml        | 15 +++++++++++++++
 1 file changed, 15 insertions(+)

diff --git a/Documentation/devicetree/bindings/remoteproc/fsl,imx-rproc.yaml b/Documentation/devicetree/bindings/remoteproc/fsl,imx-rproc.yaml
index 3a1f59ad79e2..70322e57b6ff 100644
--- a/Documentation/devicetree/bindings/remoteproc/fsl,imx-rproc.yaml
+++ b/Documentation/devicetree/bindings/remoteproc/fsl,imx-rproc.yaml
@@ -22,6 +22,7 @@ properties:
       - fsl,imx8mn-cm7
       - fsl,imx8mp-cm7
       - fsl,imx8mq-cm4
+      - fsl,imx8qxp-cm4
       - fsl,imx8ulp-cm33
       - fsl,imx93-cm33
 
@@ -54,12 +55,26 @@ properties:
     minItems: 1
     maxItems: 32
 
+  power-domains:
+    maxItems: 8
+
   fsl,auto-boot:
     $ref: /schemas/types.yaml#/definitions/flag
     description:
       Indicate whether need to load the default firmware and start the remote
       processor automatically.
 
+  fsl,entry-address:
+    $ref: /schemas/types.yaml#/definitions/uint32
+    description:
+      Specify CPU entry address for SCU enabled processor.
+
+  fsl,resource-id:
+    $ref: /schemas/types.yaml#/definitions/uint32
+    description:
+      This property is to specify the resource id of the remote processor in SoC
+      which supports SCFW
+
 required:
   - compatible
 
-- 
2.37.1