[PATCH-next v1] arm64: dts: rockchip: Enable NVM Express PCIe controller on rock3a

[Robin Murphy]

On 2022-09-27 14:46, Anand Moon wrote:
> Hi Chukun,
> 
> On Mon, 26 Sept 2022 at 23:31, Chukun Pan <amadeus at jmu.edu.cn> wrote:
>>
>> Hi,
>>
>> On 26-09-22, 06:14, Anand Moon wrote:
>>
>>> +     pcie30_3v3: gpio-regulator {
>>> +             compatible = "regulator-gpio";
>>> +             regulator-name = "pcie30_3v3";
>>> +             regulator-min-microvolt = <100000>;
>>> +             regulator-max-microvolt = <3300000>;
>>> +             gpios = <&gpio0 RK_PD4 GPIO_ACTIVE_HIGH>;
>>> +             gpios-states = <0x1>;
>>> +             states = <100000 0x0>, <3300000 0x1>;
>>> +     };
>>
>> This is actually no different from vcc3v3-pcie regulator?
>>
>>> +&pcie30phy {
>>> +     data-lanes = <0 1 2 3>;
>>> +     phy-supply = <&vcc3v3_pi6c_03>;
>>> +     status = "okay";
>>> +};
>>
>> It seems that there is no need to define additional data-lanes when
>> the pcie3x1 node is not enabled, and phy-supply seems unnecessary on
>> this board.
>>
> As per the schematic below pice support with 2 regulators
> 
> VCC3V3_PCIE        (SCT2250FPA)
> VCC3V3_PI6C_03  (PI6C557-03 is a spread spectrum clock generator
> supporting PCI Express and Ethernet requirements)

Neither of which have anything to do with the phy, which is in the SoC 
and runs off VDDA_0V9 and VCCA_1V8, see page 12. VCC3V3_PCIE is the 
general power supply for the M.2 socket, which I doubt is supposed to 
deliver 100mV when disabled.

(as a side note, is pcie2x1's vpcie3v3-supply as queued in -next 
actually correct? AFAICS the other socket is effectively powered 
straight from VCC3V3_SYS so shouldn't have needed VCC3V3_PCIE, but at 
least it's there now ready for this one)

Robin.

> 
> [0] https://dl.radxa.com/rock3/docs/hw/3a/rock3a_v1.3_sch.pdf
> 
>> Excuse me, can you try the patches I posted? Lspci can recognize
>> pcie3x2 normally, but I don't have a spare nvme hard drive right
>> now to test if it works.
>>
> 
> No, it did not work on my board, see bool logs.
> [0] https://pastebin.com/Lk93VFxg
> 
> [ 0.725985] phy phy-fe8c0000.phy.4: lane number 0, val 1
> [ 0.726975] phy phy-fe8c0000.phy.4: rockchip_p3phy_rk3568_init: lock
> failed 0x6890000, check input refclk and power supply
> [ 0.728172] phy phy-fe8c0000.phy.4: phy init failed --> -110
> [ 0.728704] rockchip-dw-pcie: probe of 3c0800000.pcie failed with error -110
> [ 0.745193] ALSA device list:
> 
> Thanks
> -Anand
> 
>> Thanks, Chukun
>>
>> ---
>> Chukun Pan (3):
>>    arm64: dts: rockchip: Add regulator suffix to ROCK3 Model A
>>    arm64: dts: rockchip: Rename pinctrl label of pcie2x1 on rock-3a
>>    arm64: dts: rockchip: Add PCIe v3 nodes to rock-3a
>>
>>   .../boot/dts/rockchip/rk3568-rock-3a.dts      | 36 ++++++++++++++-----
>>   1 file changed, 27 insertions(+), 9 deletions(-)
>>
>> --
>> 2.25.1
>>
> 
> _______________________________________________
> Linux-rockchip mailing list
> Linux-rockchip at lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/linux-rockchip