[PATCH] arm64: dts: imx8mm: Drop QCA clk out setup on Data Modul i.MX8M Mini eDM SBC

[Marek Vasut]

The PHY clock output is not connected to anything, drop the clock output
configuration. This way, the PHY does not generate output clock.

Signed-off-by: Marek Vasut <marex at denx.de>
---
Cc: Fabio Estevam <festevam at denx.de>
Cc: NXP Linux Team <linux-imx at nxp.com>
Cc: Peng Fan <peng.fan at nxp.com>
Cc: Shawn Guo <shawnguo at kernel.org>
To: linux-arm-kernel at lists.infradead.org
---
 arch/arm64/boot/dts/freescale/imx8mm-data-modul-edm-sbc.dts | 2 --
 1 file changed, 2 deletions(-)

diff --git a/arch/arm64/boot/dts/freescale/imx8mm-data-modul-edm-sbc.dts b/arch/arm64/boot/dts/freescale/imx8mm-data-modul-edm-sbc.dts
index 9dfd1e6bde54c..575d5632296c5 100644
--- a/arch/arm64/boot/dts/freescale/imx8mm-data-modul-edm-sbc.dts
+++ b/arch/arm64/boot/dts/freescale/imx8mm-data-modul-edm-sbc.dts
@@ -196,8 +196,6 @@ fec1_phy: ethernet-phy at 0 {
 			reset-gpios = <&gpio1 1 GPIO_ACTIVE_LOW>;
 			reset-assert-us = <10000>;
 			reset-deassert-us = <10000>;
-			qca,clk-out-frequency = <125000000>;
-			qca,clk-out-strength = <AR803X_STRENGTH_FULL>;
 			qca,keep-pll-enabled;
 			vddio-supply = <&vddio>;
 
-- 
2.35.1