[PATCH v6 5/7] ARM: dts: sun8i: a83t: Add MIPI CSI-2 controller node

[Paul Kocialkowski]

MIPI CSI-2 is supported on the A83T with a dedicated controller that
covers both the protocol and D-PHY. It is connected to the only CSI
receiver with a fwnode graph link. Note that the CSI receiver supports
both this MIPI CSI-2 source and a parallel source.

An empty port with a label for the MIPI CSI-2 sensor input is also
defined for convenience.

Signed-off-by: Paul Kocialkowski <paul.kocialkowski at bootlin.com>
---
 arch/arm/boot/dts/sun8i-a83t.dtsi | 43 +++++++++++++++++++++++++++++++
 1 file changed, 43 insertions(+)

diff --git a/arch/arm/boot/dts/sun8i-a83t.dtsi b/arch/arm/boot/dts/sun8i-a83t.dtsi
index 82fdb04122ca..bbe01877a938 100644
--- a/arch/arm/boot/dts/sun8i-a83t.dtsi
+++ b/arch/arm/boot/dts/sun8i-a83t.dtsi
@@ -1062,6 +1062,49 @@ csi: camera at 1cb0000 {
 			clock-names = "bus", "mod", "ram";
 			resets = <&ccu RST_BUS_CSI>;
 			status = "disabled";
+
+			ports {
+				#address-cells = <1>;
+				#size-cells = <0>;
+
+				port at 1 {
+					reg = <1>;
+
+					csi_in_mipi_csi2: endpoint {
+						remote-endpoint = <&mipi_csi2_out_csi>;
+					};
+				};
+			};
+		};
+
+		mipi_csi2: csi at 1cb1000 {
+			compatible = "allwinner,sun8i-a83t-mipi-csi2";
+			reg = <0x01cb1000 0x1000>;
+			interrupts = <GIC_SPI 83 IRQ_TYPE_LEVEL_HIGH>;
+			clocks = <&ccu CLK_BUS_CSI>,
+				 <&ccu CLK_CSI_SCLK>,
+				 <&ccu CLK_MIPI_CSI>,
+				 <&ccu CLK_CSI_MISC>;
+			clock-names = "bus", "mod", "mipi", "misc";
+			resets = <&ccu RST_BUS_CSI>;
+			status = "disabled";
+
+			ports {
+				#address-cells = <1>;
+				#size-cells = <0>;
+
+				mipi_csi2_in: port at 0 {
+					reg = <0>;
+				};
+
+				mipi_csi2_out: port at 1 {
+					reg = <1>;
+
+					mipi_csi2_out_csi: endpoint {
+						remote-endpoint = <&csi_in_mipi_csi2>;
+					};
+				};
+			};
 		};
 
 		hdmi: hdmi at 1ee0000 {
-- 
2.37.3